Switching On And Off - EFA PLE-10 Instructions D'utilisation

Betriebsanleitung für Druckluftenthäuter PLE-10
Handling

Switching on and off

•
Switch on: open the lever lock (item.A) (pull the
safety catch (item.B) backwards) and press in the
direction of the arrow "ON".
•
Switch off: release the lever (item.A).
OFF
A
ON
Fig. 4 Opening and switching the lever valve on and off
Adjusting the blade
Warning!
Before any ma nipulation of the
machine, the c ompressed air s upply
must be either closed or decoupled!
Warning!
Never put y our ha nd ne ar the s harp
side of the blade. Otherwise, you may
cut yourself badly!
Important!
Always rele ase th e clamp ing scre w
before adjusting the blade guard!
Warning!
The ma ximum tighte ning torque of
the clamp ing screw is 3 N m. Use th e
torque wrench s upplied for th
purpose!
Warning!
We a dvise cha nging the c lamping
screw after a operating time of 25 h.
To adjust the machine to the user's individual working
technique and compensate for normal blade wear, the
blade guard is adjustable. The blade can be
advanced or retracted as necessary.
The dehider knife is correctly adjusted when it leaves
our factory.
Adjusting the blade:
1. Decouple the compressed air hose from the
compressed air supply. Use the torque wrench
supplied as an accessory to release the clamping
screw (fig. 5).
B
is
Fig.
2. Push the blade guard up as far as it will go. This
will bring the blade into the best position with the
cutting edge raised to the highest point (Fig. 6).
Fig. 6
3. Push the blade guard down until the screw end
stops are reached (Fig. 7). The blade is now in the
best possible position for blade guard adjustment.
Then use the screw end stops (Fig. 7) to set the
correct blade projection. During this operation,
keep pressing the blade guard down against the
end stops with one finger.
Fig. 7
The setting is correct when the cutting edge is located
around 0.1-0.5 mm above the tooth tips in the topmost
position (Fig. 8).
GB
5
16