User Manual - Invacare Cadiz H291 Manuel D'utilisation

Compliance
Quality is of the utmost importance for our company; all
processes are based on the ISO 13485 standard.
This product features the CE mark, in compliance with the
Medical Device Directive 93/42/EEC Class 1.
Invacare is continuously working towards ensuring that the
company's impact on the environment, locally and globally,
is reduced to a minimum. We only use REACH compliant
materials and components.
For further information please contact Invacare in your
country (for addresses, see back page of this manual).
Warranty information
We provide a manufacturer's warranty for the product
in accordance with our General Terms and Conditions of
Business in the respective countries.
Warranty claims can only be made through the provider from
whom the product was obtained.
Service life
The expected service life of this product is three years when
used in accordance with safety instructions and intended
use, stated in this manual. The effective service life can vary
according to frequency and intensity of use.
Scope of delivery (Fig. 2)
The following components are included in the scope of
delivery:
Seat plate (H291 only)
A
Seat plate (H296 only)
B
Height adjustable legs (4x)
C
D Backrest (H296 only)
E

User manual

Safety
Safety information
WARNING!
Risk of injury
– Check all parts for shipping damage and test
before using.
– Do not use if defective.
– In the event of a malfunction, contact your
dealer immediately.
– Do not make any unauthorized changes or
alterations to the product.
WARNING!
Risk of falling!
– Do not stand on this product.
– Do not use as a climbing aid.
– Do not use for transfer from the side or partial
load.
– Do not sit on the product unless all four legs
have full contact to the ground.
– Do not tilt.
– Do not use outdoors.
1637297-A
WARNING!
Risk of injury
Invacare products are specifically designed and
manufactured for use in conjunction with Invacare
accessories. Accessories designed by other
manufacturers have not been tested by Invacare
and are not recommended for use with Invacare
products.
– Only use accessories intended for this product.
Labels and symbols on the product
Identification label (Fig. 1)
The identification label contains important information:
Product designation
A
Reference number
B
Lot number
C
Date of manufacture
D
E Read user manual
F This product complies with Directive 93/42/EEC
concerning medical devices. The launch date of this
product is stated in the CE declaration of conformity.
Maximum user weight
G
Manufacturer address
H
The identification label is attached to the underside
of the seat.
Setup
Safety information
WARNING!
Risk of injury
– After any adjustments, repair or service and
before use, make sure that all parts are properly
installed and secure.
CAUTION!
Risk of pinching
– Take care during assembly.
Assembling the shower stool / shower chair (Fig.
3)
Installing the legs
1. Place the seat upside down on a clean, flat and stable
surface (floor or table). Make sure that the seat plate
is not damaged.
2. Completely insert the four legs into the tube ends A
(for H291) respectively B (for H296) on the underside
of the seat.
WARNING!
Risk of falling
– Make sure that all four snap buttons G engage
in the leg tube holes with an audible click.
Installing the backrest (H296)
1. Place the shower chair on its legs.
2. Completely insert both tubes E of the backrest into the
tubes F of the seat.
3