IKA RV 3 eco Mode D'emploi page 22

- Unlock the locking device by turning it 60° anticlockwise
according to the indication mark (1). The red mark
should be visible.
- Feed the vapour tube (2) in until it stops.
- Then, lock the locking device by turning it clockwise by
60°.
- Push the lock knob to the end position. The red mark
should be covered and invisible.
- The vapour tube is not allowed to be pulled out!
- Check the correct axial locking device on the vapour
tube.
- Keep the red mark invisible.
• Mount & remove the evaporation flask
Turn clockwise for locking,
Turn anticlockwise for unlocking.
Mount the evaporation flask:
- Place the evaporation flask (4) on the vapour tube.
- Turn the plastic nut (2) with the clip (3) anticlockwise
until the clip can be put on the flange.
- Now turn the plastic nut clockwise until the clamp is
hard up against the flange. When doing so, hold the
locking device (1) on the vapour tube.
Remove the evaporation flask:
- Hold the locking device and loosen the plastic nut by
turning it anticlockwise. This releases a tightly clamped
evaporation flask.
- Hold the evaporation flask at the flange and open the
clip.
- Remove the evaporation flask.
- Check that the locking of vapour tube is still closed!
• Mount the condenser seal
1
2
3
4
1
- Place the RV 10.8001 condenser seal (1) in the
condenser receptacle and fit the glassware to the device
according to the assembly instructions.
• Mount & remove the condenser
1
Mount the condenser:
- Place the cap nut (2) into the condenser (1), and then
put the spring ring to the flange of the condenser.
- Place the condenser on the rotary drive (3) and tighten
the cap nut by hand.
- Fix the receiving flask and hose connectors as shown.
See also operating manual of glassware.
Remove the condenser:
- Use the ring spanner provided to loosen union nuts that
are tightly fitted.
- Loosen the union nut by turning anticlockwise.
2 3
22