Avintage AV46CDZI Notice D'utilisation page 32

LIGHT
To control the inner light turn on/off.
« UP »
Used to increase (warm) the set temperature by 1°C/1°F.
« DOWN »
Used to decrease (cool) the set temperature by 1°C/1°F.
SELECTOR
Select the temperature display setting in Fahrenheit or Celsius degree. To change the temperature from Fahrenheit to
Celsius or from Celsius to Fahrenheit, press the button
SETTING THE TEMPERATURE CONTROL
The wine cooler has two temperature zones. The temperature settings of LOWER ZONE and UPPER ZONE are adjustable
with the range 5º-22ºC/40º-72ºF. It is recommended to set the LOWER ZONE to 12°-22ºC / 55-72ºF which is ideal for storing
white and red wines and the UPPER ZONE to 5-12ºC / 40-55ºF which is ideal for storing sparkling and white wines.
NOTE: The temperature set for the LOWER ZONE must always be the same or higher than that in the
UPPER ZONE. For optimal performance, the set temperature of the two zones should differ by at least
4°C.
You can touch UP and DOWN mark to set the internal temperature for each zone. The degrees indicators will appear in
the display window marked
When the unit is plugged in for the first time, the LED readouts will show the original temperature sets previously (the
preset temperature at the factory for UPPER ZONE is 10ºC / 50ºF and for LOWER ZONE is 16ºC / 60ºF).
Touch the UP and DOWN mark once of each compartment to set the desired temperature.
The temperature will increase 1°C or 1ºF if you touch the UP mark once, or the temperature will decrease 1°C or 1ºF if
you touch the DOWN mark once.
To view the "set" temperature in either zone at any time, touch the UP or DOWN mark of each compartment, the "set"
temperature will temporarily "flash" in the LED display for 5 seconds. Then the display shows the current inner temperature
again.
for UPPER ZONE and
for 5 seconds
for LOWER ZONE.
32