Intended Use; Technical Data; Equipment Items; Safety Regulations - Heiniger DELTA3 Mode D'emploi

1.2 Intended use

The clipping machine is exclusively intended for the shearing of cattle and horses.
Other uses, and in particular using the machine on people, are expressly prohibited.
Indoor use only.

1.3 Technical data

Model designation:
Mains voltage:
Motor output:
RPM:
Fuse protection needed:
Dimensions (B/H/L):
Weight, excluding cable:
Max. ambient temperature: 0°C - 40°C
Max. air humidity:
Noise emission (LpA):
Acceleration (ahw):
Installation Category:
Pollution Degree:
We reserve the right to make technical changes and improvements without notice.

1.4 Equipment items

1 Clipping machine
1 Pair of clipping blades
1 Special screwdriver
1 Bottle of special lubricating oil
1 Cleaning brush
1 Operating instructions
1 Transport and storage case

2 Safety regulations

2.1 Introduction
This section describes the mandatory safety instructions which must be observed when using
the clipping machine.
All persons undertaking work on or with the machine have an obligation to read the
operating instructions.
The operating instructions must be kept safely in the storage case, and be accessible at all
times.

2.2 Symbols and warning signs

Various symbols are used in the operating instructions. They refer to potential dangers or
point to technical information, the non-observance of which will lead to injury to persons,
damage to property or inefficient operation.
4
Delta3
see machine nameplate
approx. 79 mm x 105 mm x 310 mm
1320 g
10% -90% (relative)
77 dB(A) (EN 50144-1/02.96 & EN ISO 3744/11.95)
< 2.5 m/sec2 (EN 28662-1/01.93)
II
2
Instruction manual DELTA3