Beta 1946KF Mode D'emploi page 12

LUBRICATION
For optimal use, connect the tool to a filter-lubricator unit
provided with an air-oil microfog mixer (items 1919F...), set at
two drops per minute, pouring special oil ISO 32 (item 1919L)
in. The above-mentioned accessories will translate into a high-
performing tool and wear-resistant mechanical parts.
Do not use kerosene or diesel oil.
MAINTENANCE
Should the riveter be used over long periods of time, impurities
may form on the clamps, thus causing them to slip from the
nail; clean the clamps with either petrol or some degreasers;
then lubricate them.
To lubricate, use Mobilgrease XHP 222.
We recommend replacing any worn clamps.
Regularly check the oil level, as this riveter is an air tool; fill up
whenever a shorter stroke is suddenly shown.
Take the following steps:
1) Disconnect the tool from the feeding plant.
2) Remove the nozzle holder (38).
3) Open the cylinder cover (1).
4) Remove the whole piston unit, using a plier and pulling
without loosening the nut (5).
5) Pour Mobilgrease XHP 222 directly into the body (29), filling
up under part 16.
6) After cleaning and greasing the piston stem and the rubber
piston ring (7-8), put the piston unit back in.
7) Before retightening the nozzle holder, restore the clamps
holding cone (39) and the cone holding head (42) the their
original sizes, using the spanner (63) and the drawing
enclosed with the exploded view. Then connect air and
reighten the nozzle holder keeping the lever (33) pressed.
We recommend using the enclosed exploded view as a manula
to disassemble and assemble the tool as well as to identify any
spare parts.
WARRANTY
This tool is manufactured and tested with the greatest care, in
accordance with current safety regulations, and is covered by a
12-month warranty.
We will repair any breakdowns caused by material or
manufacturing defects by fixing the defective pieces or
replacing them at our discretion. Should assistance be asked
for during the warranty period, the expiry date of this warranty
will remain unchanged.
This warranty will not cover any defects due to wear, misuse,
or breakdowns caused by blows and/or falls. In addition, this
warranty will no longer be valid if any changes are made, or if
the tool is tampered with or sent to the customer service in
pieces.
This warranty explicitly excludes any damage to people and/or
things, whether direct or consequential.
DECLARATION OF CONFORMITY TO THE "MACHINE"
DIRECTIVE
BETA UTENSILI SPA
VIA A. VOLTA, 18
20845 SOVICO (MB)
hereby certify, assuming full responsability, that the product:
PNEUMATIC AIR RIVETER FOR THREADED RIVETS
item 1946KF
complies with the following standards, according to the
requirements set by the "Machine Directive":
2006/42/CE
Place and date of issue
SOvICO (MB) ITALY
January 2015
Name and title of the person in charge
MASSIMO CICERI
(Managing Director)
SPECIFICATIONS
TRACTION POWER
MAXIMUM STROKE LENGTH
AIR INLET
WORKING PRESSURE
MAXIMUM WORKING PRESSURE 6,5 Bars
MINIMUM INTERNAL HOSE SIZE
AIR CONSUMPTION/CYCLE
WEIGHT
DIMENSIONS
(length x height x width)
SOUND PRESSURE
SOUND POWER
MAXIMUM RIvET CAPACITY
we
ITALY
14235 N
7 mm
1/4" taper GAS
5,8÷6,5 Bars
10 mm
2,1 l
2,1 Kg
278x305x79 mm
77,5 dB (A)
(pr EN 50144)
81,5 dB (A)
(pr EN 50144)
M4, M5, M6, M8
STAINLESS STEEL