Description Of The Appliance; Eco Function; Turning On The Appliance - ARIETE EcoPower 6233 Mode D'emploi

• Do not expose the appliance to atmospheric agents (rain, sun, etc.).
• For proper disposal of the product pursuant to the European Directive 2009/96/EC please read the relevant
leaflet enclosed with the product.
• sAve These InsTrucTIOns FOr FuTure reFerence
Notes: when using the iron for the first time, test it on an old piece of fabric to ensure that the sole plate and water tank are
completely clean.

DescrIPTIOn OF The APPlIAnce

A - Water tank filling cover
B - Steam adjustment selector
C - Steam button
D - Spray button
E - Iron temperature control lamp
F - Temperature adjustment knob
G - Power cord protection
H - Iron stand
I - Reference for temperature setting
L - Tank
M - SELF CLEAN button
N - Soleplate
O - Spray nozzle
P - Water measuring cup

eco Function

The appliance is equipped with a technology capable of optimizing the production of steam and, consequently, reducing
the consumption of energy.
To enable the Eco function, move the steam selector to the ECO position.
We recommend using this function for silk, wool and light cottons.
InsTrucTIOns FOr use
Filling the tank before use
Warning
Make sure the iron is unplugged from the supply mains before filling the tank with water.
Set the steam control knob (B) onto "0" (Fig. 2).
Open the door (A) by pushing it upwards and, holding the iron horizontally, fill the water tank up to the maximum level using
the measuring cup (P) provided (Fig. 5).
Close the cover (A) again. If your tap water is very hard, use natural demineralized water.
never exceed the maX mark when filling the tank.
Do not pour vinegar, descalers or other scented substances into the tank; under penalty of immediate cancellation of the
warranty.
If it proves necessary to add water while ironing, always turn off the iron and unplug the power cord before filling the tank
with water.
Open the water filling cover and turn the iron upside down to empty the tank.

Turning on the appliance

it is possible that there white powder leaks from the soleplate the first time the iron is used; this is normal, and the
effect will disappear after a few jets of steam.
you may notice a delay in the formation of steam the first time the iron is used; this is normal, and is because the
water starts to circulate inside the iron. it may be necessary to press the steam and spray button a few times for
it to operate correctly.
Rest the iron upright on the iron stand (H) (Fig. 7).
Plug it into the socket. The temperature control lamp (E) turns on.
Select the desired temperature by turning the temperature adjustment knob (F), lining it up with the reference (I) on the iron.
11