Description Of The Appliance; Switching On The Appliance - ARIETE Stiromatic NO STOP R5 Mode D'emploi

DescrIpTIOn Of The ApplIAnce

A - Power cord
B - Tank
C - Iron/boiler connection cable
D - Steam ready light
E - Iron/boiler on-off switch
F - Steam adjustment knob
G - Continous steam button
H - Continuous steam lock slider
I - Steam button
J - Iron temperature control indicator light
K - Thermostat knob
L - Iron support grid
M - Soleplate
N - Boiler
O - Boiler cleaning safety cap
InsTrucTIOns fOr use
Warning!
Remove any labels and protections from the soleplate before using the appliance for the first time.
filling the tank before use
Warning!
Make sure the appliance is unplugged from the supply mains before filling the tank with water.
Before plugging it in, completely unwind the power cord. Remove the tank (Fig. 2). Fill the tank directly beneath the tap with
cool tap water (Fig. 3).
never fill the tank beyond the maX level.
The product functions with normal tap water.
If the tap water is particularly hard (higher than 20°F), use a mixture of 50% tap water and 50% demineralized water.
never use pure demineralized water.
Do not add any additive of chemical substances to it (such as, for example, starches, sizing agents, fragrances or anything
else); otherwise, the warranty may be revoked.
Warning!
To avoid damaging the pump, never operate the appliance without any water in the tank, even for dry ironing.
Put the tank back in, paying attention to matching the tank valve with the pin inside the appliance seat (Fig. 4) Press the tank
all the way down until completely inserted and check that it is correctly installed.

switching on the appliance

Place the appliance on a horizontal and stable surface. Connect the appliance to the power supply, ensuring that the voltage
indicated on the identification plate corresponds to your local power supply.
Before you turn on the appliance, make sure there is sufficient water inside the tank.
If you want to iron with steam, turn on the appliance. Press the iron/boiler starting switch (E) Fig. 6 and turn the steam adjust-
ment knob (F) to the value you want. When the steam ready light (D) turns on, the steam is ready for use.
Set thermostat knob (K) on the desired temperature.
When first used, the iron may give out a little smoke: this transitory effect is perfectly normal and will disappear
very soon.
When first using the appliance after filling the tank, set thermostat knob (K) past the symbol (
supply button (I) Fig. 8, until the iron gives out steam (approx. 1 minute) Fig. 9. The iron is now ready for use. Before
applying a jet of steam to the article to be ironed, release two or three good jets of steam towards the floor to stabilise
the steam flow.
Warning!
Do not release steam when the iron is standing on its grille rest (L).
The boiler is now automatically filled by a pump which produces a noise (vibration) lasting a few seconds every time it is
activated. A decrease in the steam output may occur soon after the pump starts operating. This is perfectly normal, and a
after a few seconds the steam output will be normal again.
•••
) and press steam
11