Dry Ironing; Vertical Ironing - ARIETE Stiromatic NO STOP R5 Mode D'emploi

If the iron has not been used for a long time, it is advisable to keep it in a horizontal position and send a few shots of steam
to the floor in order to stabilize the jet before ironing.
steam adjustment
The appliance is equipped with a regulator (F) which allows the steam output to be adjusted from a minimum to a maximum
according to ironing requirements (Fig. 7).
shot of steam
Turn the steam adjustment knob (F) to MAX. Wait for the steam ready symbol (D) to turn on. Set the ironing temperature by
turning the adjustment knob (K) past the symbol (
the steam button (I) 3 to 5 seconds, a concentrated jet of steam will be delivered when the button is released. If the steam
supply button (I) is operated continuously for more than 30 seconds, drops of water may come from the steam holes in the
plate of the iron. It is recommended that the button (I) is used for shorter periods.
continuous steam
Turn the steam adjustment knob (F) to MAX. Wait for the steam ready symbol (D) to turn on. Set the ironing temperature
by turning the adjustment knob (K) past the symbol (
temperature is reached, press the steam button (G) Fig. 10. The cursor (H) will lock the button, making the jet of steam
exit continuously and steadily. To unlock the button (G) and stop the continuous jet, press the cursor (H) forward (Fig. 11).
Temperature selection
First check whether the fabric has a label containing ironing instructions and compare the symbol with the instructions which
follow. If there is no label with instructions, but you know the type of material, follow the instructions below.
Note that the table refers to fabrics not treated with sizing agents or similar products; if they have been, you can also iron
at a lower temperature.
When you change the temperature by turning the adjustment knob (K), the light (J) will turn on and stay on until the iron
reaches the new temperature.
filling the boiler during use
always check the level of water in the tank while you are ironing.
add enough water to the tank so that the water level is always visible. do not go past the maX level.
If the tank remains without water, you will notice a vibration and a louder noise. Turn off the appliance by pressing the switch
(E). unplug it from the electric outlet.
Warning!
Always turn off the appliance and remove the power cable plug from the socket-outlet before filling the tank with
water.
Add water directly from the tap (Fig. 3). Put the tank back on the appliance, put the plug into the socket-outlet, and turn the
appliance back on.
If the appliance is not switched off promptly, overheating of the pump could cause a momentary stoppage of the appliance.
It is therefore necessary to turn off the iron, fill the tank and wait about one hour until the appliance cools down and resumes
normal operation.

Dry IrOnIng

Dry (that is, steam less) ironing is obtained by plugging in the appliance, turning on the appliance by means of switch (E).
Put the steam adjustment knob on minimum and turn the thermostat knob (K) to the desired temperature. Do not press the
steam button.

verTIcAl IrOnIng

You can use the jet of continuous steam for ironing hanging fabrics. This special ironing procedure serves to remove
creases from curtains, fabrics, etc. Turn the steam adjustment knob (F) to MAX. Wait for the steam ready symbol (D) to turn
on. Set the ironing temperature by turning the adjustment knob (K) past the symbol (
position you want to iron it vertically and press the steam button.
Warning!
Do not iron fabrics held by other people.
12
•••
). Wait for the indicator lamp (J) of the iron to turn off. When you press
•••
). Wait for the indicator lamp (J) of the iron to turn off. When the
•••
). Put the curtain or fabric in the