Cleaning Instructions - Panasonic WH-SDC0305J3E5 Mode D'emploi

Pompe à chaleur air-eau
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 306

Cleaning instructions

To ensure optimal performance of the system, cleaning has to be carried out at regular intervals.
Consult an authorised dealer.
• Disconnect the power supply before cleaning.
• Do not use benzine, thinner or scouring powder.
• Use only soap (
pH7) or neutral household detergent.
• Do not use water hotter than 40 °C.
Indoor unit
• Do not splash water directly.
Wipe the unit gently with a soft dry cloth.
2
0.2
1
3
Water pressure gauge
0.1
0.3
0.4
MPa
bar
4
Do not press or hit the glass cover using
hard and sharp objects. Failure to do so
may cause damage to the unit.
Ensure that the water pressure is
between 0.05 and 0.3 MPa (0.1 MPa =
1 bar).
In case the water pressure is out of the
above range, consult an authorised
dealer.
MAINTENANCE
User
• In order to ensure optimal performance of the units, user may inspect and clear any obstruction on the air inlet and outlet
vents of the outdoor unit.
• Users should not try to service or replace parts of the unit.
• Contact authorised dealer for scheduled inspection.
Dealer
• In order to ensure safety and optimal performance of the units, seasonal inspections on the units, functional check of
RCCB/ELCB, water filter, field wiring and piping have to be carried out at regular intervals by authorised dealer.
Water filter
• Clean the water filter at least once a year. Failure to do
so may cause the filter to clog up, which may lead to
system breakdown. Consult an authorised dealer.
• Please also remove dust on the magnet.
Outdoor unit
• Do not obstruct the air inlet and outlet vents. Failure
to do so may result in low performance or system
breakdown. Remove any obstruction to assure the
ventilation.
• When it snows, clean and remove snow around the
outdoor unit to prevent the air inlet and outlet vents from
being covered with snow.
For extended non-use
• The water inside the Tank Unit should be drained.
• Disconnect the power supply.
Non serviceable criteria
Disconnect the power supply
then please consult an authorised dealer under the
following conditions:
• Abnormal noise during operation.
• Water/foreign particles have entered the Remote
Controller.
• Water leaks from the indoor unit.
• Circuit breaker switches off frequently.
• Power cord becomes excessively warm.
EN
35

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Wh-sdc0709j3e5Wh-ud03je5Wh-ud05je5Wh-ud07je5Wh-ud09je5

Table des Matières