Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
collection can reduce dust-related hazards.
Power tool use and care
17. Do not force the power tool. Use the correct
power tool for your application. The correct
power tool will do the job better and safer at the
rate for which it was designed.
18. Do not use the power tool if the switch does
not turn it on and off. Any power tool that cannot
be controlled with the switch is dangerous and
must be repaired.
19. Disconnect the plug from the power source
and/or the battery pack from the power tool
before making any adjustments, changing
accessories, or storing power tools. Such
preventive safety measures reduce the risk of
starting the power tool accidentally.
20. Store idle power tools out of the reach of
children and do not allow persons unfamiliar
with the power tool or these instructions to
operate the power tool. Power tools are
dangerous in the hands of untrained users.
21. Maintain power tools. Check for misalignment
or binding of moving parts, breakage of parts
and any other condition that may affect the
power tool's operation. If damaged, have the
power tool repaired before use. Many accidents
are caused by poorly maintained power tools.
22. Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges
Ampere Rating
More Than
0
6
10
12
000173
GROUNDING INSTRUCTIONS:
This tool should be grounded while in use to protect
the operator from electric shock. The tool is
equipped
with
a
three-prong grounding type plug to fit the proper
grounding type receptacle. The green (or green and
yellow) conductor in the cord is the grounding wire.
Never connect the green (or green and yellow) wire
to a live terminal. Your unit is for use on 120 volts
and has a plug that looks like Fig. "A".
Table 1: Minimum gage for cord
Not More Than
6
10
12
16
three-conductor
cord
are less likely to bind and are easier to control.
23. Use the power tool, accessories and tool bits
etc. in accordance with these instructions,
taking into account the working conditions
and the work to be performed. Use of the power
tool for operations different from those intended
could result in a hazardous situation.
Service
24. Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the power
tool is maintained.
25. Follow
changing accessories.
26. Keep handles dry, clean and free from oil and
grease.
USE PROPER EXTENSION CORD. Use only three-wire
extension cords that have three-prong grounding-type
plugs and three-pole receptacles that accept the tool's
plug. Make sure your extension cord is in good
condition. Replace or repair damaged or worn cord
immediately. When using an extension cord, be sure
to use one heavy enough to carry the current your
product will draw. An undersized cord will cause a
drop in line voltage resulting in loss of power and
overheating. Table 1 shows the correct size to use
depending on cord length and nameplate ampere
rating. If in doubt, use the next heavier gage. The
smaller the gage number, the heavier the cord.
Volts
Total length of cord in feet
120 V
25 ft.
18
18
16
14
Fig. A
and
Grounding
Blade
000088
3
instruction
for
lubricating
50 ft.
100 ft.
AWG
16
16
16
14
16
14
12
Not Recommended
Cover of Grounded
Outlet Box
and
150 ft.
14
12
12
Publicité
Table des Matières
