Unpacking And Checking Contents - Huvema HU 13 Profi Mode D'emploi

Additional safety rules
Always keep in mind that:
- the machine must be switched off and disconnected from the power supply during maintenance and repairs,
- clamped workpieces may only be measured when the machine is switched off.
Never lean over the machine, mind loose clothing, ties, jewellery etc. and wear a cap.
Do not remove safety devices or guards. Never use the machine while a guard is open.
Always use safety glasses for machining rough materials.
Burrs and chips should only be removed using a sweeper or other aid, never with your bare hands!
Never leave the machine running unattended.
2. Characteristics and applications
Chuck capacity ..................................................................................................................................... 13 mm
Taper ........................................................................................................................................................ B16
Range of spindle speeds (5) ........................................................................................... 50 Hz: 460-2480 rpm
Max. spindle travel ............................................................................................................................... 60 mm
Table size ................................................................................................................................. 197 x 202 mm
Swing ................................................................................................................................................. 250 mm
Distance spindle-table ........................................................................................................................ 290 mm
Distance spindle-base ........................................................................................................................ 408 mm
Overall height ..................................................................................................................................... 718 mm
Motor ............................................................................................................. 230 V, 375 W, 50 Hz, 1400 rpm
Weight, net/brut............................................................................................................................... 29/32.5 kilo
Packing size .................................................................................................................... 690 x 430 x 250 mm
Noise level information ................................................................................................................. 66-67 dB(A)
Subject to change.
3. Instructions for using this machine
Read the safety rules carefully and always observe them. Examine the applications of this machine and
beware of possible risks.
Always wear safety glasses.

4. Unpacking and checking contents

Drill press is shipped complete in one box.
1. Separate all "loose parts" from packaging materials
and check each item with "Table of loose parts" to
make sure all items are accounted for, before
discarding any packing material.
2. Remove the protective oil that is applied to the table
and column. Use any ordinary household type
grease and spot remover.
3. Apply a coat of wax paste to the table and column to
prevent rust. Wipe all parts thoroughly with a clean
dry cloth.
Table of loose parts (see pict. A):
Item Description
A Table/support ass.
B Column support ass.
C Huvema manual
D Box of loose parts
E Base
F Head assembly
-16-
G Bag of loose parts
60 Hz: 570-3050 rpm
Qty.
1
1
1
1
1
1
1