Automatic Cooking Programs; Chef Function (Hi1995G) - Asko HI1995G Mode D'emploi

OPERATION

Automatic cooking programs

Your hob is fitted with 6 automatic cooking programs. You can set any
end time of an automatic cooking program with the aid of the kitchen
timer function (refer to page 18). The cooking programs are based on
regular quantities. The tables are meant as a guideline, because of the
large margins you can alter the dish according to your wishes.
To set an automatic program
The cooking zone is switched on.
• Press the menu button.
A series of 6 icons will light up (7 icons
which will be brighter than the others..
• Again press the menu button, or press and hold down the menu
button to go to the next menu functions.
The selected cooking programme automatically starts after 3
seconds. An 'A' for 'automatic' appears in the display.
If an automatic cooking program is active, you can use the following
buttons to go back to the manual cooking process:
<< , + , - , >> .
Attention
For 'Vario' appliances, the cooking programs and boost function
will not work if the zones are bridged or the chef function is active.
Chef function
The 'Chef function' will activate all zones when switched on. The right-
hand zones in setting 1, the middle ones in 7 and the left-hand zones
in 12. 'Ch' will appear on the display for the rear zones. Afterwards
you can configure a different cooking setting for both zones using the
controls for the front zone.
This function enables you too cook without making use of the power
controls, but by moving the pans from zone to zone.
on the HI1995G), one of
EN 21