Charging Battery Pack; Power Level Indicator - Tennant V-LWU-13B Manuel D'utilisation

English
EN

CHARGING BATTERY PACK

The Lithium-Ion battery does not have a memory and
does not have to be fully depleted before it can be
charged again. Charging at any time during the run
cycle will not affect the battery performance or life.
1. The battery Pack is located on the back of the
vacuum. It can be charged while installed on the
vacuum, or the battery can be removed from the
vacuum and charged independently
2. Plug the AC cable into the charger and into a
properly grounded wall outlet.
WARNING: To reduce the risk of fire, explosion,
electric shock, or injury. When charging, make sure that
the charger has at least 6 inches of clearance on all
sides. Adequate airflow is required to cool the charger
when in use.
8
3. Plug the charger DC cable into the Charge Point on
the battery.
4. The charger LED light will be red while charging
and turn green when the battery back is fully charged.
The battery pack may require up to 2.5 hours to fully
charge.
After the battery pack is fully charged, the charger will
go into a maintenance mode and keep the battery fully
charged for up to 6 hours then turn off. NOTE: Battery
pack may get warm while charging. This is normal.
WARNING: To reduce the risk of fire, explosion,
electric shock, or injury. Use only Tennant Charger
1237435 and Tennant battery pack 1237436. Do not
use a battery pack that has been damaged in any way.

POWER LEVEL INDICATOR

1. Press the button on the battery to illuminate the LED
lights.
2. When the battery is fully charged there will be four (4)
green lights and one (1) red light showing.
3. As the battery is discharged, during use, the number
of green lights showing will reduce from four (4) to none
(0).
4. When all of the green lights are off and only the
red light is showing, there is a small amount of time
remaining before the battery will be fully discharged
and will require recharging.
Tennant V-LWU-13B (03-2019)