Charging Batteries - Tennant NOBLES V-WD-16B Opérateur Manuel

OPERATION
EN
3. After draining recovery tank, open cover and
thoroughly rinse out tank with clean water.
4. Replace drain hose knob securely and return to
holder.
ATTENTION: Be certain drain hose knob is secure
to prevent suction loss.

CHARGING BATTERIES

ATTENTION: To prolong the life of the batteries
and to provide optimum machine performance,
ONLY recharge the batteries after a total of 30
minutes of use or more. Do not leave batteries
discharged for lengthy periods.
The following charging instructions are intended for
battery chargers supplied with the machine. Only use a
battery charger with the following specifications to
prevent battery damage.
CHARGER SPECIFICATIONS:
S
OUTPUT VOLTAGE - 24 VOLTS
S
OUTPUT CURRENT - 15 AMPS
S
AUTOMATIC SHUTOFF CIRCUIT
S FOR DEEP CYCLE BATTERY CHARGING
1. Push the machine to a flat, dry surface in a well-
ventilated area for charging.
WARNING: Fire Or Explosion Hazard.
Batteries Emit Hydrogen Gas. Keep Sparks And
Open Flame Away. Keep Battery Compartment
Open When Charging.
2. Open battery compartment. Unlatch lower latches
at front of machine and carefully tilt upper housing
backwards to floor (Figure 16).
NOTE: Make sure to drain the tank prior to accessing
the batteries.
FIG. 16
10
3. Before charging the batteries, check the electrolyte
level in each battery cell (Figure 17).
FOR SAFETY: When servicing machine, wear
protective gloves and eye protection when
handling batteries or battery cables. Avoid contact
with battery acid.
The electrolyte level (A) should slightly cover the
battery plates (B). Add distilled water as needed.
DO NOT OVERFILL, the fluid may expand and
overflow while charging. Replace cell caps before
charging (Figure 18).
A
B
4. Connect the charger's AC power supply cord to a
properly grounded receptacle (Figure 19).
Grounded
3 Hole Outlet
Ground Pin
FIG. 19
FIG. 17
FIG. 18
V- WD- 16B / V- WD- 61B (04- 10)