Extention Cords; Installation; Unpack The Machine - GreenWorks 1403402 Manuel D'utilisation

NOTE
Servicing of a product with double insulation requires
extreme care and knowledge of the system and
should be performed only by a qualified service
technician. For service, we suggest you return the tool
to your nearest authorized service center for repair.
Always use original factory replacement parts when
servicing.
13

EXTENTION CORDS

When using a power tool at a considerable distance
from a power source, be sure to use an extension cord
that has the capacity to handle the current the product
will draw. An undersized cord will cause a drop in line
voltage, resulting in overheating and loss of power. Use
the chart to determine the minimum wire size required in
an extension cord. Only round jacketed cords listed by
Underwriter's Laboratories (UL) should be used.
When working outdoors with a product , use an
extension cord that is designed for outside use. This
type of cord is designated with "W-A" or "W" on the
cord's jacket. Before using any extension cord, inspect it
for loose or exposed wires and cut or worn insulation.
MINIMUM GAUGE FOR EXTENSION CORDS (AWG)
(WHEN USING 120 V ONLY)
Total Length of Cord in Feet (me-
Ampere Rating
Not
More 25' (7.6
More
Than m)
Than
0 6 18
6 10 18
10 12 16
12 16 14
Extension Cord – Make sure your extension cord is in
good condition. When using an extension cord, be sure
to use one heavy enough to carry the current your
product will draw. An undersized extension cord will
cause a drop in voltage resulting in loss of power and
overheating. The table shows the correct size to use
depending on cord length and name plate ampere
rating. If in doubt, use the next heavier gauge. The
smaller the gauge number, the heavier the cord. To
reduce the risk of disconnection of appliance cord from
the extension cord during operating:
1. Make a knot as shown in Figure A. or
2. Use one of the plug-receptacle retaining straps or
connectors.
METHOD OF SECURING EXTENSION CORD
English
ters)
100' 150'
50' (15
(30.4 (45.7
m)
m) m)
16 16 14
16 14 12
16 14 12
Not Recommen-
12
ded
THE CORD AS SHOWN
CONNECT PLUG AND RECEPTACLE
WARNING
Keep the extension cord clear of the working
area.Position the cord so that it will not get caught on
lumber, tools, or other obstructions while you are
working with a power tool. Failure to do so can result
in serious personal injury.
WARNING
Check extension cords before each use. If damaged
replace immediately. Never use the product with a
damaged cord since touching the damaged area could
cause electrical shock resulting in serious injury.
14

INSTALLATION

14.1 UNPACK THE MACHINE

WARNING
Make sure that you correctly assemble the machine
before use.
WARNING
• If the parts have damage, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the
service center.
1. Open the package.
9
EN