Connect The Poles; Adjust The Length Of The Polesaw; Convert Chainsaw To Polesaw; Convert Polesaw To Chainsaw - GreenWorks 1403402 Manuel D'utilisation

EN
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with
local regulations.

14.2 CONNECT THE POLES

1. Insert the intermediate pole into the rear handle.
2. Tighten screws with screwdriver (not included).
14.3 ADJUST THE LENGTH OF THE
POLESAW
8
1. Loose the collar (9) by turning it counterclockwise.
2. Pull / Push the telescoping shaft (8) to adjust the
length of the polesaw.
3. Turn the collar clockwise to tight it.
9
English
14.4 CONVERT CHAINSAW TO
POLESAW
1. Lift the quick release latch (16) and cover at the
bottom of the chainsaw.
2. Insert the telescoping shaft to the chainsaw.
14.5 CONVERT POLESAW TO
CHAINSAW
1. Lift the quick release latch (16) and cover at the
bottom of the chainsaw.
2. Pull to remove the telescoping shaft from the
chainsaw.

14.6 CUTTING PREPARATION

Before you start to cut, make sure that
• Wear heavy gloves for maximum grip and
protection.
• Maintain a proper grip on the machine during

operation.

• Use your right hand grip on the rear handle while
your left hand grip on the pole shaft.
• Keep your body to the left of the chain line.
• Never use a left-handed (cross-handed) grip, or
any stance that places your body or arm across
the chain line.
• Never stand directly under the limb you are cutting.
• Periodically examine the tightness of the collars
during operation.
15 OPERATION
Before you plug in, examine if the rated mains voltage
and mains frequency, as tell on the rating label, match
your power supply.
Before operation, examine if the mains connection
cable and extension cable have damage. Only use the
mains connection cables and extension cables in good
condition.
10
WARNING
WARNING