Transportation And Storage; Troubleshooting; Technical Data - GreenWorks 1403402 Manuel D'utilisation

EN
• the groove does not fit with the height of the drive
links (which must never touch the bottom).
• the inside of the guide bar is worn and makes the
chain lean to one side.
17 TRANSPORTATION AND
STORAGE
Before you move the machine, always
• Pull the mains plug out of the socket.
• Keep hands clear of the lock-out button.
• Put the scabbard on the guide bar and the chain.
Before you put the machine into storage, always
• Pull the mains plug out of the socket.
• Clean all unwanted material from the machine.
• Make sure that the storage area is
• Not available to children.
• Away from agents which can cause corrosion,
such as garden chemicals and de-icing salts.
18

TROUBLESHOOTING

Problem
The machine
does not start
Possible cause Solution
Assemble the
The poles are
poles according
not assembled
to the instruc-
correctly.
tions.
1. Push and
hold the
lock-out but-
ton
The lock-out 2. While you
button and trig- hold the
ger are not de- lock-out but-
pressed at the ton, pull the
same time. trigger.
3. Release the
lock-out but-
ton to start
the machine.
English
Problem
The bar and
chain gets hot
and smokes.
The bar and
chain gets too
hot and can not
cut.
The motor runs,
but the chain
does not cut cor-
rectly, or the
motor stops af-
ter around 3
seconds.
19

TECHNICAL DATA

Motor
No load speed
Guide bar length
Chain pitch
Chain gauge
Drive links
Chain oil capacity
Weight (without battery
pack)
16
Possible cause Solution
Oil tank is emp- Fill the oil tank.
ty.
Refer to the
manual to re-
The discharge
move the bar
port is blocked.
and clean out
the debris.
1. Clean the oil
tank.
Inlet opening of
2. Fill with
inner oil tank is
clean bar
blocked.
and chain lu-
bricant.
The sprocket is 1. Clean the
stuck and clog- sprocket.
ged with debris.
2. Fill with
clean bar
and chain lu-
bricant.
Refer to Adjust
The chain ten-
the Chain Ten-
sion is too tight
sion in the man-
or too loose.
ual.
Sharpen or re-
The chain is dull
place the chain.
Take out the
The chain is put chain and turn it
on backwards. in the right direc-
tion.
1. Release the
When you use
trigger.
the machine un-
der load, it
2. Start the ma-
stops.
chine again.
Lubricate the
The chain is not chain to de-
lubricated. crease the fric-
tion.
120V, 60Hz, 6A
5000 - 5500 RPM
10" (250 mm)
3/8" LP (9.5 mm)
.050" (1.3 mm)
40 DL
80 ml
10.4 lbs. (4.7 kg)