Christopeit Sport DELTA Notice De Montage Et D'utilisation page 19

Step 4:
Attach the computer (1) at handlebar support (68).
1. Push the plug of the connection cable (67) projecting from the handlebar
support (68) into the associated socket of the computer (1).
2. Push the plugs of the pulse cables (73) projecting from the handlebar
support (68) into the associated sockets of the computer (1).
3. Place the computer on the plate provided for it on the handlebar support
(68) and attach it with the screws (3).
Step 5:
Installation of saddle (9) and saddle slide (10) at saddle support (15).
1. Insert the saddle support (15) into the provided holder of the main frame
(43) and secure at the desired position by screwing in the quick release
(66). (Note: To screw in the quick release (66), the threaded hole in the
main frame (43) and one of the holes in the saddle support (15) must be
aligned. Furthermore, ensure that the saddle support (15) is not pulled
out of the main frame beyond the marked maximum position. The setting
of the saddle post can be adjusted as desired later. For this, the quick
release (66) must be loosened by only a few revolutions, the cap of the
lock must be pulled away and the saddle adjusted. Then secure the
new setting by tightening the quick release (66).
2. Place the seat slide (10) into the holder of saddle support (15), set it at
the desired horizontally position and tighten it by using hand grip nut
(24) and washer.
3. Push the saddle (9) with saddle bracket into the movable saddle slide
(10) and tight it up into desired incline position.
19