Standard Accessories; Applications - Ryobi EAG600RS Manuel D'utilisation

GB
FR DE ES
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
Recycle raw materials instead of disposing
of as waste. The machine, accessories and
packaging should be sorted for environmental-
friendly recycling.
SPECIFICATIONS
Wheel diameter
Thickness
Voltage
Input
Spindle thread
Rated speed
Overall length
Net weight
NOTE: Be sure to check the nameplate on the product,
because the voltage is subject to change depending on
the area in which the product is to be used.
Maximum circumferential speed of grinding wheel: 4,800
m/min.
Example of calculation
3.14 x 115 x 12,000/1,000 =
Circumferential speed
grinding wheel
Wheel diameter
Rated speed of grinder

STANDARD ACCESSORIES

Auxiliary handle, Wrench.
A grinding wheel is included in the standard accessories
for some countries.

APPLICATIONS

Use only for the purposes listed below:
 Grinding metals
IT NL PT DK SE
115 mm (4.5 in)
6 mm
230 V - 240 V 50 Hz
600 W
M14
12,000 min‫¹־‬
325 mm
2.0 kg
4,330
of
4,330
115
12,000
FI NO RU PL CZ
English
OPERATION
See fi gure 3.
Keep safety guards in place. Never cover the air vents
since they must always be open for proper motor
cooling.
The key to effi cient operating is controlling the pressure
and surface contact between the disc and work piece. Flat
surfaces are ground at an acute angle, usually 10 to 20
degrees with the work piece. Allow the disc to reach full
speed before starting to grind. Too great an angle causes
concentration of pressure on a small area which may
gouge or burn work surface.
SWITCH
See fi gure 2.
1. This tool is started and stopped by sliding and
releasing the switch.
2. For the convenience of continuous operation, slide the
switch along then press the front end down to lock it.
3. To release the lock, press the rear end of the switch.
MOUNTING THE GRINDING WHEEL
See fi gure 4 - 5.
1. Attach the disc fl ange and the wheel on the spindle
before fi tting the clamp nut.
2. Ensure that the wheel is correctly seated over the boss
on the disc fl ange and clamp nut.
3. Depress the lock button located on the right side of
gear case.
4. Using the wrench provided, tighten the clamp nut in a
clockwise direction.
Check carefully whether or not there are cracks in the
wheel. Replace a cracked wheel immediately.
WHEEL GUARD ADJUSTMENT
See fi gure 6.
Never use the angle grinder without the wheel guard in
place properly adjusted.
1. Unplug the tool.
2. Using the spindle lock button and wrench provided,
loosen and remove the clamp nut, grinding disc and
3
HU RO LV LT EE
WARNING
WARNING
WARNING
HR SI SK GR TR