Operation; Safety Instructions; Other Symbols In This Documentation; Units Of Measurement - Stiebel Eltron SHZ 30 LCD Utilisation Et Installation

OPERATION

Safety

1.1.3 Keywords
KEYWORD Meaning
DANGER Failure to observe this information will result in serious
injury or death.
WARNING Failure to observe this information may result in serious
injury or death.
CAUTION Failure to observe this information may result in non-
serious or minor injury.
1.2

Other symbols in this documentation

Note
General information is identified by the symbol shown
on the left.
f Read these texts carefully.
Symbol Meaning
Material damage
!
(appliance, consequential and environmental damage)
Appliance disposal
f This symbol indicates that you have to do something. The ac-
tion you need to take is described step by step.
1.3

Units of measurement

Note
All measurements are given in mm unless stated oth-
erwise.
www.stiebel-eltron.com
2. Safety
2.1

Intended use

The appliance is intended for heating domestic hot water and can
supply one or more draw-off points, depending on the operating
mode.
Any other use beyond that described shall be deemed inappropri-
ate. Observation of these instructions and of instructions for any
accessories used is also part of the correct use of this appliance.
Any modifications or conversions to the appliance void all war-
ranty rights.
2.2

Safety instructions

WARNING Burns
During operation, the tap or safety assembly can reach
temperatures in excess of 60 °C.
There is a risk of scalding at outlet temperatures in ex-
cess of 43 °C.
WARNING Injury
!
Where children or persons with limited physical, sensory
or mental abilities are allowed to control this appliance,
ensure that this will only happen under supervision or
after appropriate instruction by a person responsible
for their safety.
Children should be supervised to ensure that they never
play with the appliance!
Material damage
!
Protect the water lines and the safety assembly against
frost.
Note
Sealed unvented operating mode: The appliance is under
pressure. During the heat-up process, expansion water
will drip from the safety valve. If water continues to drip
when the heat-up process is completed, please inform
your qualified contractor.
Note
Open vented operating mode: Whenever water is heated
up, expansion water will drip from the spout.
2.3

CE designation

The CE designation shows that the appliance meets all essential
requirements according to the:
- Electromagnetic Compatibility Directive
- Low Voltage Directive
2.4

Test symbols

See type plate on the appliance.
SHZ LCD | 25