Jonsered CS 2234 Manuel D'utilisation page 13

Masquer les pouces Voir aussi pour CS 2234:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3. Push the air purge bulb 6 times.
4. Hold the body of the product on the ground with
your left hand.
5. Put your right foot through the rear handle.
6. Pull the starter rope handle slowly with your right
hand until you feel some resistance.
7. Pull the starter rope handle with force.
298 - 004 - 14.10.2019
CAUTION: Do not pull the starter
rope until it stops. Do not let go of the
starter rope when it is fully extended.
Release the starter rope slowly. If
you do not obey these instructions, it
can cause damage to the engine.
Note: Do not pull the throttle trigger when you
start the engine.
8. Continue to pull the starter rope handle until the
engine starts or tries to start (pull max 5 times).
9. If the engine starts or tries to start, push the
choke control in to the half choke position.
10. Continue to pull until the engine starts.
11. Hold the rear handle with your right hand and the
front handle with your left hand.
12. Immediately pull the front hand guard rearward in
the direction of the front handle to disengage the
chain brake.
Note: The chain will move.
13

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Cs 2238

Table des Matières