Sony TA-VE800G Mode D'emploi page 18

Preparing and Using the Remote
6
When "PUSH YOUR COMMANDER" appears on
the TV screen, press the button on your audio/
video equipment's remote that corresponds to the
control button highlighted on the TV screen.
is the POWER switch.
1
9
When programming the IR code, point the remote
at the IR sensor on the amplifier from a distance
no greater than 10 cm (4 inches) and hold down
the button on the remote for about 5 seconds until
the instruction "RELEASE YOUR
COMMANDER" appears and the IR code setting
indicator turns off.
IR sensor
Keep the remote pointed horizontally at the IR
sensor until the code is programmed.
If you tilt or move the remote during the
programming process, the IR code may not be
recorded correctly.
Repeat this procedure for the remaining buttons
After you've programmed all the IR codes, the IR CODE
SETTING menu reappears.
To programme special IR codes that do not appear
as on-screen controls
See "Programming Other Infrared (IR) Codes (USER IR
setting)" on page 20.
7
Repeat steps 3 to 6 to programme IR codes from
other programme sources.
To exit to the main menu
Click EXIT.
To return to a previous menu
Click RETURN.
18 GB
IR CODE SETTING
0 ( ) p P =
2 3 4 5 6 7
10/0 >10 REC
PUSH YOUR COMMANDER
CODE CLEAR
RETURN EXIT
To erase IR codes
Click CODE CLEAR.
• To erase a specific IR code
1 Click SINGLE IR CODE CLEAR.
2 Click the button you want to clear.
"Are you sure?" appears for confirmation.
3 Click YES to erase the code.
"CODE CLEAR!" appears in the display.
To stop before erasing a code, click NO.
To erase another code repeat steps 2 and 3.
+
• To erase all the IR codes for the current component (e.g.,
8
OTHER CD)
1 Click (OTHER CD) CODE CLEAR.
"Are you sure?" appears for confirmation.
2 Click YES to erase the codes.
"CODE CLEAR!" appears in the display.
To stop before erasing the codes, click NO.
• To erase all the IR codes
1 Click ALL IR CODE CLEAR.
"Are you sure?" appears for confirmation.
2 Click YES to erase the codes.
"CODE CLEAR!" appears in the display.
To stop before erasing all the codes, click NO.
If the IR codes do not operate as expected
• Perform the programming operation(s) again to make sure
the IR codes were programmed correctly.
• If you experience difficulty operating the INPUT, number,
or ENTER buttons of a video deck or laserdisc player after
automatic registration from the manufacturer list in step 5.
Programme the IR codes for that equipment manually as
shown in step 6.
• On some laser disc players made by other manufacturers,
the ) and 0 buttons may not operate correctly even
after automatically registration from the manufacturer list
in step 5. If this happens, perform step 6 to manually
programme the IR codes for the ) and 0 buttons, as
well as any other buttons that you want to use with the
laser disc player.
• If you register a playback source as TOSHIBA 2 or RCA 2,
you cannot turn the TV set on or off using the amplifier's
remote (the power will not go on when you click TEST).
• Some IR codes may not have been successfully
programmed, even if "RELEASE YOUR COMMANDER"
appears on the TV screen. In this case, try programming
the IR code again. If the IR code still cannot be
programmed, follow the procedure described in
"Programming Other Infrared (IR) Codes (USER IR
setting)" on page 20.
• The unit may not be able to record IR codes with special
waveforms produced on some remotes.