Sony TA-VE800G Mode D'emploi page 17

4
Click "Sony" for a Sony product or OTHER for a
non-Sony product.
IR CODE SETTING
MAKER Sony
OUTPUT IR
RETURN
If the programme source is a Sony product
The IR codes are programmed automatically and
registration is complete (click RETURN or EXIT).
To take advantage of CONTROL-A1 compatible audio
components, such as multi-disc CD players, click
CONTROL-A1 to select CONTROL-A1.
5
Click the respective programme source.
IR CODE SETTING
MAKER Sony
OUTPUT IR
VCR
LD
CD
RETURN
If the equipment is not a video deck or laser disc
player
Cover the IR sensor on the equipment to prevent
accidental operation during the programming
procedure, click START, then go to step 6.
IR CODE SETTING
MAKER Sony
OUTPUT IR
VCR
LD
CD
RETURN START
OTHER
EXIT
OTHER
TAPE
DAT
MD
TUNER
EXIT
OTHER
TAPE
DAT
MD
TUNER
EXIT
Preparing and Using the Remote
If the equipment is a video deck or laser disc player:
1 Click START.
A list of other manufacturers appears.
2 Click the manufacturer of the respective equipment
and the IR codes for that programme source are
registered automatically. (If the manufacturer is not
listed, cover the IR sensor on the equipment to
prevent accidental operation during the
programming procedure, click "OTHER", then go to
step 6).
3 Click TEST.
If the selected programme source turns on, it means
the IR codes have been registered. This ends the
procedure.
If the programme source does not turn on, click the
number button beside the manufacturer's name to
select another number, then click TEST again. If the
programme source still does not turn on, cover the IR
sensor on the equipment to prevent accidental
operation during the programming procedure, click
"OTHER", then go to step 6.
When using a video deck from another manufacturer
Check to see if the supplied remote uses -/-- or 1- and 2-
buttons to enter 2 digit programme positions.
Since the -/-- or 1- and 2- codes are not pre-
programmed in this unit, do the following operations to
programme these codes manually.
1 Select the manufacturer (as shown in step 2 above).
2 Click -/-- 2- CODE SET.
VCR MAKER SETTING
EMERSON 1 2 3 4
FISHER 1 2 3 4
PANASONIC 1 2
TOSHIBA 1 2
MISTUBISHI 1 2 3
GRUNDIG
HITACHI
PHILIPS
– / – – 2 – CODE SET
RETURN TEST
3 When "PUSH YOUR COMMANDER" appears on the
TV screen, press the button on your VCR's remote
that corresponds to the control button highlighted on
the TV screen (see step 6 for details).
–/–– 2– CODE SETTING
1 –, – / –– CODE
2 – CODE
PUSH YOUR
RETURN
AKAI 1 2
GE 1 2
JVC 1 2
RCA 1 2
SANYO 1 2
SHARP
ZENITH
OTHER
EXIT
– / ––
2 –
COMMANDER
CODE CLEAR
EXIT
(continued)
17 GB