Displays And Settings Of The On-Board Computer - Bosch Kiox BUI330 Notice D'utilisation D'origine

English – 14
More detailed instructions regarding this can be
found in the online operating instructions at
www.Bosch-eBike.com/Kiox-manual.
Software updates
Software updates are transferred from the app to the
on-board computer in the background as soon as the
app is connected with the on-board computer. If an
update has been fully transferred, this is shown three
times upon restarting the on-board computer.
Alternatively, you can check for the presence of any
updates via <Sys settings>.
Powering external devices from the USB
port
The USB port can be used to operate or charge most
devices that can be powered via USB (e.g. various
mobile phones).

Displays and settings of the on-board computer

Note: All interface displays and texts on the following
pages correspond to the release status of the soft-
ware. The interface displays and texts may change
slightly following a software update.
Operating logic
You can use the < (10) and > (8) buttons to switch
between the different riding value information pages
(even while riding). This way, you can keep both
hands on the handlebars while cycling.
You can use the + (12) and – (11) buttons to in-
crease or decrease the assistance level.
The <Settings> that can be accessed via the Status
screen cannot be changed while riding.
You can use the select button (9) to perform the fol-
lowing functions:
– You can access the quick menu while riding.
– You can access the settings menu from the Status
screen while stationary.
– You can confirm values and acknowledge informa-
tive hints.
– You can exit a dialog.
1 270 U20 XBK | (16.04.2020)
Charging requires the on-board computer to be
mounted and a sufficiently charged battery to be in-
serted in the eBike.
Open the protective cap (17) for the USB port on the
on-board computer. Use a Micro-A – Micro-B USB
charging cable (available from your Bosch eBike
dealer) to connect the USB port on the external de-
vice to the USB port (6) on the on-board computer.
Once the electrical load has been disconnected, the
USB port must be carefully resealed with the protec-
tive cap (17).
A USB connection is not a watertight plug connec-
tion. When cycling in wet conditions, ensure no
external devices are connected and that the USB
port is fully covered by the protective cap (17).
Attention: Any electrical devices connected can re-
duce the range of the eBike.
If the on-board computer is removed from its holder
and not switched off, it will display information re-
garding the last journey, as well as status information,
on a loop.
If no button is pressed after the on-board computer is
removed from the holder, it will switch itself off after
one minute.
Screen sequence
Provided the on-board computer is fitted to the
holder, you can view the following displays one after
the other:
1. Start page
2. Time and range
3. Distance and journey time
4. Power and cadence
5. Average and maximum speed
6. Distance, range, power and heart rate
7. Heart rate
8. Calories burnt and total distance
9. Status page
Bosch eBike Systems