Cameo ZENIT W600i Manuel D'utilisation page 20

DEVICE SETTINGS (Settings)
Press MODE to access the main menu (--- Menu ---). Using the UP and DOWN controls, select the
menu item Settings (observe arrow) and confirm with ENTER.
---------------- Menu ----------------
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
This will take you to the submenu for setting the following submenu items (see table, select with
UP and DOWN, confirm with ENTER, change value or status with UP and DOWN, confirm with
ENTER):
Settings (device settings)
= Display lighting
Display
Backlight
= Operating status with
DMX Fail
DMX signal fault
= Dimmer curve
Dimmer
Curve
= Dimmer response
Dimmer
Response
20
On Permanently on
Off Deactivation after approximately 1
minute of inactivity
Hold Last command is retained
Blackout Activates blackout
Emergency Spotlight changes to colour macro
Light "Cold White"
Linear Light intensity increases linearly with
DMX value
Exponential Light intensity can be finely adjusted
at lower DMX values and broadly
adjusted at higher DMX values
Logarithmic Light intensity can be broadly adjust-
ed at lower DMX values and finely
adjusted at higher DMX values
S-curve Light intensity can be finely adjusted
at lower and higher DMX values and
broadly adjusted at medium DMX
values.
LED Lamp responds abruptly to changes in
DMX value
Halogen Spotlight behaves like a halogen spot-
light with soft brightness changes