Flex BME 8-4 Notice D'instruction D'origine page 28

Sanding:
NOTE
After placing the machine on the workpiece
and before switching it on, check that the
belt is situated fully on the rollers.
– Pipes are machined between the rollers
21 and 22.
– The angle of contact and the stock removal
rate can be varied by the contact pressure.
– The smaller the pipe diameter, the larger
the possible angle of contact. Up to 270°
are possible.
Sealing the surface:
Many manufacturers recommend sealing
finished surfaces with a protective spray
(see Flex stainless steel accessories).
For further information on the manufac-
turer's products go to www.flex-tools.com.
Belt grinder attachment FBE 8-4
WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
Attaching or changing the sanding belt
Pull out the mains plug.

28
TRINOXFLEX BRE 8-4 / BSE 8-4 / FBE 8-4
Remove handle (1.).

Swivel the housing cover to the side (2.).

Turn eccentric screw and release

sanding belt (3.).
Remove sanding belt (4.) (optional).

Pull on new sanding belt and position

centrally on the sanding arm (5.).
Tighten sanding belt by turning the

eccentric screw.
Close housing cover in front of the

housing again.
CAUTION!
Observe the specified running direction of
the belt! Running direction must correspond
with the arrow on the gear head.