Flex BME 8-4 Notice D'instruction D'origine page 21

TRINOXFLEX BRE 8-4 / BSE 8-4 / FBE 8-4
Hold the device by the insulated grip

surfaces, as the sanding belt may come
into contact with the power cord itself.
A damaged live cable may cause metal
parts of the device to become live and
result in an electric shock.
Do not use the electric power tool if it has

a damaged power cord. Do not touch the
damaged power cord and pull out the
mains plug if the power cord is damaged
during work. Damaged power cords
increase the risk of an electric shock.
Use the electric power tool for dry sanding

only. If water penetrates the electric power
tool, there is an increased risk of electric
shock.
When working, guide the electric power

tool with both hands. The handle must be
attached! Do not switch on the machine
until both hands are in the grip position.
Keep hands away from the running

sanding belt. There is a risk of injury
caused by crushing in the area of the guide
rollers. On account of the operating mode
and the guaranteed flexibility of the power
tool these danger areas cannot be
completely shielded.
Dust released from materials, such as lead

paints, some types of wood, minerals and
metal, may be hazardous to the operator
or people in the vicinity. Inhaling or
touching these dusts may result in
respiratory diseases and/or allergic
reactions.
– Ensure the work place is well ventilated!
– If possible, use external dust extraction.
– It is recommended to wear a respirator
mask belonging to filter class P2.
Do not work on materials which release

hazardous substances (e.g. asbestos).
Never grind or cut light metals which have

a magnesium content greater than 80%.
Risk of fire!
If power tools are used outdoors or are

exposed to excessive amounts of metal
dust, connect them via a residual-current-
operated circuit-breaker (tripping current
maximum 30 mA). Do not use any worn,
torn or severely clogged sanding belts.
Damaged sanding belts may rip, fly off and
cause an injury.
Before using the machine, check that the

grinding tools have been installed and
secured correctly. Switch on the machine
at no load for 30 seconds!
Interrupt the test run immediately if violent

vibrations occur or other damage is estab-
lished. Check the machine to determine
the cause.
Do not load electric power tool to such an

extent that it comes to a standstill or the
sanding belt slips.
Before putting down the electric power

tool, switch it off and wait until it comes to
a standstill.
Do not clamp the electric power tool in a

vice.
Always lay the power cord to the rear away

from the electric power tool.
Clamp the workpiece if it is loose or not

positioned securely by its own weight.
Store and handle grinding tools according

to the manufacturer's instructions.
Safety instructions for power tool
with belt grinder attachment
WARNING!
Read all safety instructions and other
instructions. Failure to observe the safety
instructions and other instructions may
result in an electric shock, fire and/or serious
injuries . Keep all safety instructions and
other instructions in a safe place for the
future.
Hold the device by the insulated grip

surfaces, as the sanding belt may come
into contact with the power cord itself.
A damaged live cable may cause metal
parts of the device to become live and
result in an electric shock.
Do not use the electric power tool if it has

a damaged power cord. Do not touch the
damaged power cord and pull out the
mains plug if the power cord is damaged
during work. Damaged power cords
increase the risk of an electric shock.
Use the electric power tool for dry sanding

only. If water penetrates the electric power
tool, there is an increased risk of electric
shock.
21