Operation - Husqvarna LB 146i Manuel D'utilisation

3. Put the stay in the groove on the cutting cover.
4. Attach the 2 stops that lock the stay and the handle.
Push them fully into position.
Note:
There are 2 stops, one identified with an H
and one with a V. Put the stop with an H on the right
side and the stop with a V on the left side.
CAUTION:
product if the 2 stops are not attached.
Introduction
WARNING:
product, you must read and understand the
safety chapter.
Husqvarna Connect
Husqvarna Connect is a free app for your mobile device.
The Husqvarna Connect app gives extended functions
for your Husqvarna product:
• Extended product information.
• Information about, and help with, product parts and
servicing.
12
Do not operate the

Operation

Before you operate the
To adjust the handle height
1. Remove the handle stay from the lower handle.
a) Put the handle stay in the top hole (A) to
decrease the handle height.
b) Put the handle stay in the bottom hole (B) to
increase the handle height.
To start to use Husqvarna Connect
1. Download the Husqvarna Connect app on your
mobile device.
2. Register in the Husqvarna Connect app.
3. Do the instruction steps in the Husqvarna Connect
app to connect and register the product.
A
B
1680 - 003 - 26.11.2021