Hatco SERV-RITE SRB Série Manuel D'installation Et D'utilisation page 11

Replacing the Heat Lamps
WARNING
Use only Genuine Hatco Replacement Parts when service
is required. Failure to use Genuine Hatco Replacement
Parts will void all warranties and may subject operators of
the equipment to hazardous electrical voltage, resulting in
electrical shock or burn. Genuine Hatco Replacement Parts
are specified to operate safely in the environments in
which they are used. Some aftermarket or generic
replacement parts do not have the characteristics that will
allow them to operate safely in Hatco equipment.
Use only low pressure halogen light/heat lamps that meet
or exceed National Sanitation Foundation (NSF) standards
and are specifically designed for food holding areas.
NOTE: Hatco halogen heat lamps meet NSF standards for food
holding and display areas. For 120V applications use
Hatco part number 02.30.117.00. For 220, 230, and
240V applications use Hatco part number 02.30.126.00.
NOTE: The glass shield inside the lamp cover is loose and will
drop down with the lamp cover. Make sure to support
the lamp cover with one hand during removal of the
screws.
NOTICE
Lamp
Holder
Lamp
Lamp
Cover
MAINTENANCE
Screw