Ryobi ETS-1525SC Mode D'emploi page 19

MOUNT THE ELEVATING AND LOWERING HANDLE
AND THE TILTING HANDLE (FIG. 1)
Mount the evaluating handle(13) on the shaft
on the left hand size of the saw and fix it by
tightening the set screw in the handle (fig 1).
MOUNT THE BLADE (FIG. 1, 2&3)
Remove the table insert (17) by removing the
four Philips flat head screws. (Fig. 3)
Turn the elevating handle (13) (Fig 1) in the
counterclockwise direction to raise the blade
shaft to its highest position (Fig 3). Remove
the blade fixing nut by turning in a
counterclockwise direction, then pull the outer
flange form the shaft and the outer arbor.
Mount the blade (15) (be sure that the teeth
are facing downwards at the front side of the
saw. Replace the outer flange and re-lit the
blade fit the blade fixing bolt. Check that
MOUNT THE RIVING KNIFE (FIG. 4&5)
If in place, remove the table insert (17) by
removing the four Philips flat head screws.
Insert the riving knife(20), so that the long
slots in the riving knife fit around the hexagon
socket head end screws(Fig 4). Adjust the
riving knjfe(20) so that the clearance between
riving knife(20) and blade (15) is between 2 to
5 mm (Fig. 5), then tighten and hexagon
MOUNT THE RIP FENCE (FIG. 6)
Loosen the rip fence lock knobs(24) on the
sliding block(19), then slide the fence(6) onto
the bolt heads and tighten the rip fence lock
knobs(24) (Fig.6)
To lock the rip fence(6), slide the rip fence
assembly until the indicator is pointing to the
Mount the tilting handle(11) (Fig. 2). Fix
the handle by tightening the screw in the
handle.
the blade is correctly seated before
lightening the bolt.
Check again that the blade is (15) securely
tightened and re-fit or adjust riving knife as
necessary, before remounting the table
insert (17).
WARNING!
Replace table insert when worn.
socket headed screws. Check to ensure
the riving knife (20) and saw blade (15) is in
line, Then check again that the blade is
securely tightened and remount the table
insert.
Then mount the blade guard (7) (Fig. 5)
desired setting. Then press rip fence lock
handle (4) downwards, to lock the fence
into position.
Ensure the fence is locked before operating
the saw.
12