Before Starting The Engine - KLIPPO Brilliant S Instructions D'utilisation

Engines: Briggs & Stratton; Quantum XLS 50, Intek Edge 60 and Intek Pro 65.
Before starting, we recommend that you carefully read instruction manual in order to obtain
Safety instructions for power lawnmower with horizontally rotating blades
These instructions are to be carfully studied before the lawnmower is used.
1. Keep hand and feet clear of the rotating blades and
never put your hand or foot into any ejector opening
without first making sure that the blade is not moving
and the ignition cable is disconected from the spark
plug.
2.Do not touch the blade until the ignition cable has
been disconected from the spark plug. Rotating the
blades may cause the engine to start.
3.Do not leave the machine unattended without stopping
the engine.
4.The engine speed regulator must not be disabled. The
pre-adjusted number of revolutions may not be changed.
Protections and safety devices may not be taken away
or be set out of function.
5. Do not top up with fuel when the engine is warm. Don´t
smoke while filling up with fuel or in the near of the
tank. WARNING! Petrol is very flammable! Store the
fuel in containers intended for petrol. Don´t remove
UPPER HANDLE
Fitted without tools, with a strong nut on the articulated
plate.
HANDLE POSITION
When required, the handle can be rotated laterally to some
extent by means of the handle joint, e.g., when mowing
close to hedges or house walls. The handle can be set to
different positions for the best operating position. The
handle can be altered in height at the chassis mount by
turning the nylon knobs (fig. 1).
Before starting engines for the first time: fill with oil (fig 8.) and READ THE ENCLOSED INSTRUCTION MANUAL FOR THE ENGINE!
Unscrew the dipstick and fill up with approx 0,6 lit. of
engine oil, viscosity SAE 30, Klippo oil no. 7201 or accor-
ding to the engine manual. Fill up to the full graduation
mark on the dipstick (do not fill above it).
NB. THE OIL IS DRAINED PRIOR TO DELIVERY!
The fuel tank opening have on certain engine types of
engines a blue transport protection. This should be remo-
ved before the first start. If you put it back again, the engine
will stop after a while. When operated for the first time,
the silencer will change colour and may smoke briefly.
OIL CHECK
Check the oil level before starting and every five hours.
Take off the dipstick and dry it up. Screw the dipstick into
the tube completely and make sure that the oil reaches
the FULL mark (fig. 3).
Instruction manual for
KLIPPO LAWNMOWERS
Models: Next, Comet, Pro S and Pro S HD.
Congratulations on purchasing a Klippo Lawnmower!
the best from your mower.
Fitting and adjustment

Before starting the engine

the fuel filler or fill up with fuel while the engine is
running.
6. Never allow children or other persons whom are not
familiar with the machine to operate the lawnmower.
Even if the machine has very effective protections it
could throw out solid objects that can cause injurys.
7.Keep the lawn as clear as possible of stones or other
objects that the lawnmower can strike. Avoid driving
over gravel paths etc.
8.Famillarize lawnmower operators with the risks and
explain how accident are to be avoided.
9.The machine may not be used for any other purpose
than cutting grass.
10.Wear pants and suitable shoes while cutting grass.
Beaware that a lawn could be slippery!
11.Comet SE: Don' leave the machine with the ignition
key!
SETTING THE CUTTING HEIGHT(fig. 2)
Move the lever forwards for taller grass. The lever positions
correspond to 3-6 mm grass height. All the weels are set
simultaneously in one operation. Make use of the efficient
height setting of the KLIPPO lawn-mowers when mowing
edges or trimming.
Never cut grass unnecessarily short. This makes spreading/
collection more difficult and increases the risk of
"scalping".
Next: By cutting high gras the spreader in the cutting deck
could be taken off by loosen the two screws in the rear
upper edge of the cutting deck.
RUNNING-IN and FIRST OIL CHANGE
The engine has already been adjusted and required no
running-in as such, although you should run it at no more
than moderate load for the first few hours. Remember to
change the oil the first time after five hours of operation
(fig. 9), and then every twenty-five hours.
PETROL
Use leadfree 95 octane petrol. Stop the engine before
filling. Do not overfill the tank so much that it overflows.
Leave around 6 mm for the fuel to expand.
Don´t let the machine stay over the winter with petrol in
the tank. This could cause starting problems in spring.
GB
17