HOLZMANN MASCHINEN KAM 45PRO Mode D'emploi page 32

Operation has been cancelled,
machine does not start
Note 1: Troubleshooting
When the Motor error and show
parts according to the procedure. First remove the top ventilation cover (A) and the sliding plate
support assb (B), then remove the chain adjusting chip assb (C) and the chain (D), also remove
the feed roller
A
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY
CONNECTION TO THE ELECTRICITY GRID.
Should you in necessary repairs not able to properly to perform or you have
not the prescribed training for it always attract a workshop to fix the
problem.
HOLZMANN MASCHINEN GmbH
 Temperature rise is too high
 Voltage error
 Feeding motor error, feeding
roller glued
 Heating error temperature higher
than 220°C (430°F)
 Temperature detecting wire error
, please turn off the power and clean and disassemble the
(E) to clean the
B
NOTICE
www.holzmann-maschinen.at
 Let the machine cool down,
then press the main switch
ON-OFF again.
 Check power supply voltage
 Clean feeding roller
 Switch off the machine and
let cool down the heating
 Contact customer service
gap between the
D
C
TROUBLESHOOTING
Gear Reduction.
E
32
KAM45PRO