Important Safety Instructions; Area Light - DeWalt DCL074 Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English
Important Safety
Instructions

WARNING!
light, basic precautions should always be followed,
including the following:
a ) Read all the instructions before using the area light.
b ) To reduce the risk of injury, close supervision is
necessary when an area light is used near children.
c ) To reduce the risk of electrical shock, do not put
area light in water or other liquid. Do not place
or store area light where it can fall or be pulled into a
tub or sink.
d ) Only use attachments recommended or sold by
the manufacturer.
e ) Risk of electric shock. Do not expose to rain.
Store indoors.
f ) To reduce the risk of injury, do not stare at
operating lamp. Serious eye injury could occur.
SAVE THESE
INSTRUCTIONS
Specific Safety Rules for Area Lights

WARNING: Fire hazard. Do not operate area light
near flammable liquids or in gaseous or explosive
atmospheres. Internal sparks may ignite fumes
causing personal injury.
Do not submerge area light in any liquid.
The area light is intended for commercial and
household use.
Before using battery and area light/charger, read all
instructions and cautionary markings on area light/
charger and battery pack.
Store the area light indoors when not in use. Keep out of
reach of children.
DO NOT attempt to charge the battery pack with any
chargers other than the ones in this manual. The area
light and battery pack are specifically designed to
work together.
Place the area light away from any heat source.
Do not disassemble area light. Take it to an authorized
service center when service or repair is required. Incorrect
reassembly may result in a risk of electric shock,
electrocution or fire.
Secure the area light in upright position while transporting.

WARNING: To reduce the risk of fire, do not place
anything on top of the lens during or after operation
of the light.

WARNING: Do not place the area light in a position
which may cause anyone to intentionally or
unintentionally stare into the area light. Serious eye
injury could result.
2
The label on your light may include the following symbols. The
symbols and their definitions are as follows:
V ......................... volts
Hz ....................... hertz
min ..................... minutes
When using the area
.../min .............. per minute
BPM .................... beats per minute
IPM ..................... impacts per minute
RPM .................... revolutions per
sfpm ................... surface feet per
SPM .................... strokes per minute
A ......................... amperes
W ........................ watts
Important Safety Instructions for the

Area Light


BATTERIES AND CHARGERS
The battery pack is not fully charged out of the carton.
Before using the battery pack and charger, read the
safety instructions below and then follow charging
procedures outlined. When ordering replacement battery
packs, be sure to include the catalog number and voltage.
Your tool uses a D
instructions before using your charger. Consult the chart
at the end of this manual for compatibility of chargers and
battery packs.
Important Safety Instructions for All
Battery Packs

n o ....................... no load speed
or DC ...... direct current
n ......................... rated speed
...................... Class I Construction
(grounded)
minute
minute
or AC ........... alternating current
or AC/DC .... alternating or
direct current
WARNING: Read all safety warnings and all
instructions for the battery pack and area light.
Failure to follow the warnings and instructions
may result in electric shock, fire and/or
serious injury.
The area light is intended for workspace lighting
only. Use as directed. Any other uses may result in risk of
fire, electric shock or electrocution.
Do not expose the area light to rain or snow.
When operating the area light outdoors, always
provide a dry location.
WALT charger. Be sure to read all safety
e
READ ALL INSTRUCTIONS
WARNING: Read all safety warnings and all
instructions for the battery pack, charger and
power tool. Failure to follow the warnings and
instructions may result in electric shock, fire and/
or serious injury.
Do not charge or use the battery pack in explosive
atmospheres, such as in the presence of flammable
...................... Class II
Construction
(double insulated)
...................... earthing terminal
..................... safety alert symbol
..................... visible radiation
..................... wear respiratory
protection
..................... wear eye
protection
..................... wear hearing
protection
..................... read all
documentation
..................... hot surface
..................... on/off button
..................... pinch/crush hazard

Publicité

Table des Matières
loading

Table des Matières