DeWalt DCL074 Guide D'utilisation page 10

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English
Using and Controlling the Area Light
(Fig. A)
nOTE: For best results, make sure your battery pack is
fully charged.
On/Off Button (Fig. A)

CAUTION: Do not stare into the area light lens.
Serious eye injury could result.
To turn the light on, press the power button
off, press the power button again.
Brightness Levels
The area light has 3 brightness levels, up to 5000 lm. To set
light levels, first press the power button to turn the light on.
You can press the brightness button
the three brightness levels or set a custom brightness level
using the Tool Connect™ application.
ECO Mode
The area light's ECO Mode feature gradually reduces
brightness to extend battery run time. To turn ECO mode
off, press and hold the brightness button
indicator will go off.
The brightness levels and ECO mode are also controllable
using the D
WALT Tool Connect™ application.
e
Low Battery Indicator
As the battery nears a fully discharged state, the light will
blink twice. The light will continue to blink twice every 45
seconds until the battery is fully discharged at which time
the light will turn off. Indication time will vary based on
battery pack capacity.

WARNING: Stop work and replace the battery when
this occurs.
MAINTENANCE

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
Accessories

WARNING: Since accessories, other than those
offered by D
WALT, have not been tested with this
e
product, use of such accessories with this tool could be
8
Recommended accessories for use with your tool
are available at extra cost from your local dealer or
authorized service center. If you need assistance in
locating any accessory, please contact D
Tool Co., 701 East Joppa Road, Towson, MD 21286, call
1-800-4-D
 4 
. To turn it
www.dewalt.com.
Repairs
The charger and battery pack are not serviceable.

 5 
to change to one of
Register Online
and the green
 5 
Thank you for your purchase. Register your product now for:
Register online at www.dewalt.com/register.
Three Year Limited Warranty
D
faulty materials or workmanship for three years from
the date of purchase. This warranty does not cover part
failure due to normal wear or tool abuse. For further detail
of warranty coverage and warranty repair information,
visit www.dewalt.com or call 1-800-4-D
433-9258). This warranty does not apply to accessories
or damage caused where repairs have been made
or attempted by others. THIS LIMITED WARRANTY IS
GIVEN IN LIEU OF ALL OTHERS, INCLUDING THE IMPLIED
WARRANTY OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE, AND EXCLUDES ALL INCIDENTAL
OR CONSEQUENTIAL DAMAGES. Some states do not allow
limitations on how long an implied warranty lasts or the
exclusion or limitation of incidental or consequential
damages, so these limitations may not apply to you. This
warranty gives you specific legal rights and you may have
other rights which vary in certain states or provinces.
In addition to the warranty, D
by our:
hazardous. To reduce the risk of injury, only D
recommended accessories should be used with
this product.
WALT (1-800-433-9258) or visit our website:
e
WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement, when
applicable) should be performed by a D
service center or a D
WALT authorized service center.
e
Always use identical replacement parts.
WARRAnTY sERViCE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with your product.
COnFiRMATiOn OF OWnERshiP: In case of
an insurance loss, such as fire, flood or theft, your
registration of ownership will serve as your proof
of purchase.
FOR YOUR sAFETY: Registering your product will
allow us to contact you in the unlikely event a safety
notification is required under the Federal Consumer
Safety Act.
WALT will repair, without charge, any defects due to
e
e
WALT
e
WALT Industrial
e
WALT factory
e
WALT (1-800-
e
WALT tools are covered

Publicité

Table des Matières
loading

Table des Matières