Machine Assembly - Stiga B 1.0 EJ Manuel D'utilisation

22
EN

4. MACHINE ASSEMBLY

WARNING!
ry carefully so as not to impair the safety and
efficiency of the machine. If in doubt, contact
your dealer.
WARNING!
not plugged into the mains socket.
WARNING!
ing the assembly should be done on a flat and
stable surface, with enough space for moving
the machine and its packaging, always mak­
ing use of suitable equipment.
Disposal of the packaging should be done in ac-
cordance with the local regulations in force.
1. MOUNTING THE FRONT HANDGRIP
(Fig. 1)
WARNING!
(1) is to ensure a minimum distance be twe en
the rear handgrip and the front one, for safety
reasons. This spacer must always be fitted
and must not be modified in any way.
– Fit the lower part (3) with guard on the drive tube
– Fit the front handgrip (4) by using the screws (5).
– Before tightening the screws (4), align the hand-
grip correctly with respect to the drive tube.
– Fully tighten the screws (4).
2. MOUNTING THE ROD (Fig. 2)
– Push the lower part of the rod (1) right down until
the stop pin (2) clicks into the hole (3) in the rod.
This is easier to do if you rotate the lower part of
the rod (1) slightly in both directions; insertion
is completed when the stop pin (2) protrudes
completely from the hole (3).
– Once inserted, tighten the knob (4) securely.
3. MOUNTING THE GUARD (Fig. 3)
WARNING!
with the same guard for grass trimmer and
brush cutter provided. The guard cannot be
changed. No other guard except the one pro­
vided may be used.
Mount the components ve
Make sure the machine is
Unpacking and complet­
The purpose of the spacer
The machine is supplied
– Remove the blade (if fitted) as described in pa-
ragraph 4.
– Loosen the two screws (1) and remove the cap
(2) with its bracket (3).
– Apply the guard (4) and refit the cap (2), tighte-
ning the two screws (1) in the holes in the bra-
cket (3).
• Mounting the additional guard (Fig. 4)
– Assemble the additional guard ( 5 ) by clicking
the tabs ( 6 ) into place in their respective slots
in the guard ( 4 ). Ensure that the tabs click in
completely.
4. REMOVING AND REFITTING
THE CUTTING DEVICES
WARNING!
devices or ones homologated by the Ma nu­
facturer.
• 3 point blade (Fig. 5)
WARNING!
and fit the blade guard.
NOTE
left-hand thread and so must be unscrewed in a
clockwise direction and screwed up anticlockwise.
– Unscrew the nut (5) clockwise.
– Pull out the outer ring-nut (7), then remove the
blade (1).
– Pull out the washer (6) and the outer ring-nut (7)
and remove the blade (1).
When mounting,
– Ensure that the grooves in the inner ring-nut (8)
match up perfectly with the angle transmission
(3).
– Fit the blade (1) and outer ring-nut (7).
– Refit the nut (5) fully tightening it in an anti-clock-
wise direction.
– Remove the wrench (2) to restore blade rotation.
• Cutting line head (Fig. 6)
NOTE
left-hand thread and so must be unscrewed in a
clockwise direction and screwed up anticlockwise.
MACHINE ASSEMBLY
Use only original cutting
Wear protective gloves
The fastening nut (5) has a
The cutting line head has a