Chubbsafes ZETA Guide De L'utilisateur page 2

USER INSTRUCTIONS
The lock operates with a numeric six-digit code or word of six letters. A secondary code can be added.
Each key press is confirmed with an audio and light signal.
After entry of a valid code a double signal follows. An invalid entry is followed by a long signal. After 10
seconds without entry all procedures are cancelled.
OPEN (see fig A)
Enter code (factory code = 1-2-3-4-5-6) and turn
the handle to open the door. If not opened within
3 seconds the lock will secure automatically. If
code entry failed on first attempt wait 20 seconds
then re-enter. Three long signals indicate the lock
bolt is jammed, release the handle and re-enter
code.
To lock simply close door and turn handle to closed
position. Check blocking by trying to turn handle
back.
Entering four consecutive invalid codes – keypad is
blocked for 5 minutes. During this period the light
flashes every 10 seconds and any key press causes
a long signal. After 5 minutes entering two further
invalid codes restarts the 5 minutes blocking
ACTIVATE THE SECOND OPENING CODE (see fig B)
Press and hold key "1" until the double signal; the
light remains on whilst:
 Enter in the main code; double signal
 Enter the new second code; double signal
 Enter the new second code again; double beep
The secondary code can be changed like the main
code. With the main code the second code can be
deleted; the main code cannot be deleted.
CHANGE CODES with door open (see fig C)
Press and hold key "0" until the double signal; the
light remains on whilst:
 Enter in the old code; double signal
 Enter the new second code; double signal
 Enter the new second code again; double beep
In case of error (long signal), the old codes remains
valid
DELETE THE SECOND USER (see fig D)
Press and hold key "3" until the double signal; the
light remains on whilst:
 Enter in the main code; double signal
The secondary code is now deleted
2
ENGLISH