Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. Check the shear bolts and other bolts at frequent inter-
vals for proper tightness to ensure that the equipment
is in safe working condition.
3. After each snow removal season, run the snow thrower
for a few minutes to prevent the collector/impeller from
freezing. Shut off the motor, wait for all revolving parts
to stop completely, and wipe residual ice and snow
off the unit. Rotate the chute direction handle several
times to remove any excess snow.
Replacing the Rubber Plates
Note: When replacing worn rubber plates, pay close
attention to carefully distinguish between the coarse
and smooth side of the plates. Place the coarse side
inside and the smooth side outside.
1. Detach the worn rubber plate by removing the two sets
of nuts, bolts, and washers used to secure it.
2. Install the new rubber plate so that the coarse side
faces inward and the smooth side faces outward.
3. Insert the bolt with the small flat washer into the cor-
responding holes on each end of the rubber plate. Use
the large flat washer and locknut to secure the bolt on
each end. Install the other rubber plate in the same
way. (fig. 12 - 14)
Replacing the Scraper
The scraper is located at the base of the snow thrower
beneath the rotor housing.
1. Detach the worn scraper from the snow thrower by
removing the 3 screws that hold it in place. (fig. 15 & 16)
2. Install the new scraper and fasten it securely to the
snowthrower with 3 screws. (fig. 15)
Replacing the Belt
Note: Determine the left and right sides of the snow-thrower
by standing behind the unit in the normal operating position.
1. Remove the screws from the left panel of the snow-
thrower.
2. Lift the belt tension and roll the belt off the big pulley.
(fig. 17)
3. Replace the belt by following instructions in reverse
order. (fig. 18)
Storage
1. Allow the unit to cool and clean the unit before stor-
ing or transporting. Be sure to secure the unit while
transporting.
2. Disconnect the extension cord from the snow thrower.
3. Inspect the extension cord closely for signs of wear or
damage. Replace it if it is worn or damaged.
4. Inspect the snow thrower carefully for worn, loose, or
damaged parts. Check connections and screws and
tighten if necessary.
5. Store the unit, along with the disconnected extension
cord, in a locked, dry place our of the reach of children
to prevent unauthorized use or damage. Cover loosely
with a tarp for added protection.
12
Electric Snow Thrower Operator's Manual
Repair Service
Repairs to electric power tools should only be carried out
by specialist electrical personel.
UK
Mantis UK Limited
Orchard House
Hempshaw Lane
Stockport
Cheshire SK1 4LH
Phone - 4401614741525
Europe
Mantis France SARL
20 rue des Garennes
57155 Marly
France
Tél 330387628888
Or contact your local Mantis authorised dealer.
Waste Disposal and Environmental
Protection
If your device should become useless somewhere in the
future or you do not need it any longer, do not dispose
of the device together with your domestic refuse, but dis-
pose of it in an environmentally friendly manner.
Please dispose of the device itself at an according col-
lecting/recycling point. By doing so, plastic and metal
parts can be separated and recycled. Information con-
cerning the disposal of materials and devices are avail-
able from your local administration.
Publicité
Table des Matières
