Copy Function - Johansson profino 6610 Mode D'emploi

COPY FUNCTION

This function allows to transmit all settings from one unit to another unit or import from the memory stick (optional).
Copy from unit to unit.
q q q q
B I-FM B III/DAB UHF 1 UHF 2
: 12-24 VDC GND
johansson
®
profino
MULTI CHANNEL
PROGRAMMABLE FILTER-AMPLIFIER
Ref.: 6610
DATA OUTPUT
TEST q
(-30dB)
SLAVE
> Connect master and slave unit with a DSUB9 male/male crossed cable.
> Then connect mains to the units.
> Push the rotary button for more than 3 seconds to enter into programming mode (see page 5).
3 s.
> Turn the button to select the
> Push the rotary button for more than 3 seconds to enter the selected mode.
3 s.
> Push the rotary button to confirm Data Import.
Note:
If a problem occurs during data transmission the display will show an error message:
Possible causes are: wrong type of cable, no cable, bad pin contacts.
All actions have to be
done on the SLAVE unit.
The MASTER unit remains
in Stand-by.
Data
Data mode.
Data
Data
15
q q q q
B I-FM B III/DAB UHF 1 UHF 2
: 12-24 VDC GND
johansson
®
profino
MULTI CHANNEL
PROGRAMMABLE FILTER-AMPLIFIER
Ref.: 6610
DATA OUTPUT
TEST q
(-30dB)
MASTER
The software version is displayed,
followed by a dot.
The LED is green.
The LED is now red.
"AL "is displayed.
A dot is displayed.