System Connection - Bosch VCM9736/10T Manuel D'installation

VCM9736/10T & VC973650T | Installation Instructions

System connection

1. Connect the PIR covert camera to the Eazeo system monitor
using the supplied cable.
2. Connect the system monitor to the mains.
3. Switch on the mains power switch.
4. The monitor checks the system. After a short time the PIR covert
camera image appears on the monitor screen.
5. If necessary adjust contrast /brightness and/or color (See the
View Settings menu of the monitor) to optimize the image on the
system monitor.
6. Adjust the viewing direction of the camera and ensure that the
picture display on the monitor is level.
Note
The image sensors in modern CCD cameras are highly sensitive and
require special care for proper performance and extended lifetime.
Please follow the guidelines to get optimum results of your camera:
• Do not expose to direct sunlight or bright spotlights in operating
and non-operating conditions.
• Avoid bright lights in the field of view of the camera.
• These bright lights will cause a smearing effect, which is
visible as white lines above and below the highlight.
• Bright lights may cause bleaching of the sensor's color filters.
This will be visible as colored spots in the picture and is
irreversible.
Focus
The built-in lens provides an optimal image sharpness for objects
between 1 metre and infinity (depth of field). The focus is preset. No
further adjustment is required.
Bosch Security Systems | 2003-09 | Version 1
EN | 9