Elbro SMSB10 AD Mode D'emploi page 26

SMSB10 AD V1.02
Supply 10 to 30 VDC
+
2.4 Installing / Exchanging the SIM Card:
Be absolutely certain the SMSB10 AD is disconnected from the power source before
inserting or exchanging the SIM card.
Open the housing cover: Insert a small screwdriver into the slit on the front of the housing
cover, press in and lift (do not remove the antenna).
Installing / Exchanging the SIM Card: Disconnect power. Flip up the SIM card holder. If
exchanging, remove the old SIM card and slide the new one into the guide. Flip down the
SIM card holder and to lock, press down and simultaneously push the upper part of the card
holder against the direction of the arrow until reaching the stop.
Close the housing cover: Press until it engages.
26
-
SIM
Relay output
SIM Card Holder
(under the cover)
NO
COM
NC