Applications; Safety Directives - Elbro SMSB10 AD Mode D'emploi

SMSB10 AD V1.02

1.3 Applications

Building control
Industrial plants
Pumping stations
Water distribution systems
Traffic engineering/ Railway technology / Vehicles
Energy management
Purification plants
Combined heat and power plants

1.4 Safety Directives

Installation of the SMSB10 AD is to be carried out by an electrical specialist.
The momentary system status remains upon power outage.
The SIM card owner is solely responsibility for protecting against misuse of the card.
2 Commissioning
2.1 Extent of Supply
SMSB10 AD Butler
Antenna
These Operating Instructions
2.2 Functional Prerequisites
Obtaining an SIM Card:
You can obtain a personal SIM card from the telephone company of your choice. You will
receive a telephone number and a PIN code with your SIM card.
Preparing your SIM card for use with your SMSB10 AD Butler:
- Insert the SIM card into your mobile phone.
- Deactivate the PIN interrogation.
- Delete all entries from the telephone book of the SIM card.
- In the first position of the telephone book enter the 4 digit password that you
wish to use to operate your SMSB10 AD.
e.g.,: Digits: 1234
Name: Heating, Garage door
Carry out the entries in accordance with the instructions for your mobile.
Mobile Signal Availability:
Before installing your SMSB10 AD, ensure smooth operation by checking its installation lo-
cation—use your mobile phone to make certain that an adequate signal is continually re-
ceivable there from your mobile network.
2.3 Installation
Installing your SMSB10 AD Butler:
Install your SMSB10 AD on a suitable mounting rail. Then connect the voltage supply (12 or
24 V ) and the device to be switched in accordance with the following schematic.
DC
Connect the antenna cable: Tighten the nut using flat spanner (width across flats: 8).
25