Correct Posture - Makita DUR361U Manuel D'instruction

Hex wrench storage
014747
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
Installing nylon cutting head
(optional accessory)
CAUTION:
If during operation the nylon cutting head
•
accidentally impacts a rock or hard object the
trimmer should be stopped and inspected for
any damage. If the nylon cutting head is
damaged it should be replaced immediately.
Use of a damaged nylon cutting head could result
in serious personal injury.
NOTICE:
Be sure to use genuine Makita nylon cutting head.
•
Turn the tool upside down so that you can replace the
nylon cutting head easily.
1
2
3
014764
Insert the hex wrench through the hole on the protector
cover and rotate the receive washer until it is locked
with the hex wrench. The nylon cutting head onto the
threaded spindle directly and tighten it by turning it
counterclockwise. Remove the hex wrench.
To remove the nylon cutting head, turn the nylon cutting
head clockwise while holding the receive washer with
the hex wrench.
Installing the wire guard (optional accessory)
CAUTION:
Before adjusting the wire guard, wait for the
•
cutting head comes to standstill. Do not adjust the
wire guard with your foot.
1. Hex wrench
1
1. Nylon cutting
head
2. Receive washer
3. Hex wrench
014761
To reduce the risk damaging the objects in front of the
cutting head, insert the wire guard so that it controls the
cutting range of the mowing line.
1
2
014762
Slightly expand the wire guard outward and then insert it
into the holes of the protector.
NOTE:
Do not expand the wire guard outward too much.
•
Otherwise it may break.
014763
When wire guard is not in use, lift it for the idle position.
OPERATION

Correct posture

WARNING:
Always position the tool on your right-hand
•
side so that the shaft of the left handle is
always in front of your body. Correct positioning
of the tool allows for maximum control and will
reduce the risk of serious personal injury caused
by kickback.
13
1. Holes
2. Wire guard