Jøtul F 105 Série Manuel D'installation Et D'utilisation page 19

4.5 Fitting a fl ue pipe with a top outlet
The product is supplied from the factory with the smoke outlet
fi tted for the top outlet.
Fig. 19
1. Thread the fl ue pipe (A) through the top plate and place it
in the top smoke outlet.
2. Seal well with a gasket (B).
4.6 Fitting a fl ue pipe with a rear outlet
The product is supplied from the factory with the smoke outlet
fi tted for the top outlet. If you want a rear outlet, proceed as
follows:
Fig. 20
A
B
1. Remove the baffl e by lifting at the rear edge, and remove
the two screws. Then twist it out of the burn chamber.
Fig. 21
1. Place the product in a correct position. See fi g. 1
2. Remove the exhaust defl ector (A).
ENGLISH
A
A
19