Jøtul F 105 Série Manuel D'installation Et D'utilisation page 16

ENGLISH
4.3 Preparations for Jøtul F 105 with
base
Fig. 10
A
3
9. Take out the gloves, baffl e, bag of screws, external air
connector and adapter lying in the burn chamber.
10. 1. Unscrew the screw placed in the middle of the rear side
of the side plate.
2. Remove the side plate (C).
3. Remove the transport screw (D) that fastens the stove
to the wooden pallet.
11. Check that the control lever (A) moves easily.
12. Lift the stove from the pallet and set it up (see fi g. 1).
16
B
1
2
C
D
Fig. 11
A
13. Install the height adjustment screws with plastic caps
placed in the bag of screws.
14. Lift the stove from the pallet.
15. Set up the stove and adjust to a horizontal position with the
4 height adjustment screws. Use the hex key placed in the
bag of screws. Mark on the wall if there has to be a rear
outlet for fl ue pipe and external air supply. NB: Take into
account the height of the fl oor plate.
Approval label
Fig. 12
A
16. Take the approval label (A) out of the burn chamber and
fasten it with the screw (B), as displayed. Tighten the screw
with a cap wrench. NB: Do not cut off the wire used for
fastening the label.
A
A
B