Polarized Plugs - DeWalt DW625 Guide D'utilisation

Tools built with this insulation system are not intended to be
grounded. As a result, your tool is equipped with a two-prong plug
which permits you to use extension cords without concern for
maintaining a ground connection.
NOTE: Double insulation does not take the place of normal safety
precautions when operating this tool. The insulation system is for
added protection against injury resulting from a possible electrical
insulation failure within the tool.
CAUTION: When servicing all tools, USE ONLY IDENTICAL
REPLACEMENT PARTS.

Polarized Plugs

Polarized plugs (one blade is wider than the other) are used on
equipment to reduce the risk of electric shock. When provided,
this plug will fit into a polarized outlet only one way. If the plug
does not fit fully into the outlet, reverse the plug. If it still does not
fit, contact a qualified electrician to install the proper outlet. Do
not change the plug in any way. Repair or replace damaged cords.
Additional Specific Instructions for
Routers
• Hold power tools by insulated gripping surfaces, because
the cutter may contact its own cord. Cutting a "live" wire
may make exposed metal parts of the tool "live" and shock the
operator.
• Use clamps or another practical way to secure and
support the workpiece to a stable platform. Holding the
work by your hand or against the body leaves it unstable and
may lead to loss of control.
• Metal cutting with router: If using router for metal cutting,
clean out tool often. Metal dust and chips often accumulate
on interior surfaces and could create a risk of serious injury,
electrical shock or death.
• Never run the motor unit separate from the base. The
motor is not designed to be handheld.
• Keep handles dry, clean and free from oil and grease. This
will enable better control of the tool.
• Maintain a firm grip with both hands on the tool to resist
starting torque. Maintain a firm grip on the tool at all times
while operating.
• Use sharp cutters. Dull cutters may cause the router to
swerve or stall under pressure.
• Keep hands away from cutting area above and below the
base. Never reach under the workpiece for any reason.
Keep the router base firmly in contact with the workpiece when
cutting.
• Never touch the bit immediately after use. It may be
extremely hot.
• Do not use router bits with a diameter in excess of 2-3/8"
(60 mm) in this tool.
• Always follow the
recommendations as some bit designs require specific
speeds for safety or performance. If you are unsure of the
proper speed or are experiencing any type of problem, contact
the bit manufacturer.
• Do not hand-hold the router in an upside-down or
horizontal position. The motor can separate from the base if
not properly attached according to the instructions.
• Before starting the motor, check to see that the cord will
not snag or impede the routing operation.
• Before starting the motor, clear the work area of all
foreign objects.
• Keep cutting pressure constant. Do not overload motor.
• Provide clearance under workpiece for bit when through-
cutting.
• Do not press spindle lock button while the motor is
running. Doing so can damage the spindle lock.
• Always make sure the work surface is free from nails and
other foreign objects. Cutting into a nail can cause the bit and
the tool to jump.
3
bit manufacturer's speed