DeWalt DW621 Guide D'utilisation page 10

2. Set the fine adjuster to zero using the inner ring. Hold the top
portion while setting the lower ring to zero.
3. Rotate the fine adjuster to the required position. Graduations are
on the top of the fine adjustment knob.
FIG. 5
REVOLVER
DEPTH
STOP
Lock-On/Lock-Off Switch (Fig. 7)
The lock-on/lock-off
FIG. 7
switch is located in the
THUMB LOCK
handle on the right side.
The router is normally
locked-off.
To start the router, press
the thumb lock and
squeeze the trigger.
To lock the switch on,
squeeze the trigger,
press the thumb lock
forward and release the
trigger. To turn the router
FIG. 6
FINE
ADJUSTMENT
0.
KNOB
TRIGGER
PRESS TO
LOCK ON
9
off, release the switch. If the tool is locked-on, press the trigger
again and release the switch.
NOTE: Loosen the plunge limiter and allow the router carriage to
return to its rest position before switching off.
OPERATION
WARNING: To reduce the risk of injury, turn unit off and
disconnect it from power source before installing and
removing accessories, before adjusting or when making
repairs. An accidental start-up can cause injury.
CAUTION: Before connecting tool to power source, check
to see that the switch is in the "OFF" position. An accidental
start-up can cause injury.
CAUTION: Turn the router on before plunging the cutter head
into the workpiece.
After setting the cutting depth as described, locate the router such
that the bit is directly over the place you will be cutting. With the
router running, lower the unit smoothly down into the workpiece.
(DO NOT JAM THE ROUTER DOWN). When the tool reaches the
pre-set depth, tighten the plunge lock. When you have finished
routing, loosen the plunge lock and let the spring lift the router
directly out of the workpiece.
NOTE: Always feed the router opposite to the direction in which the
cutter is rotating.
Direction Of Feed
Figures 8 and 9 show proper direction of feed for some typical cuts.
Mold the outside edge of a piece of stock by a) mold the end
grain, left to right, b) do the straight grain side moving left to right,
c) finish the other end grain side, and d) do the remaining straight
grain edge.
The direction of feed is important in router usage. Be sure the cutter
is rotating into the stock by moving left to right on outside edges
and clockwise on inside cuts.