Further Information; Troubleshooting - JVC GZ-MS100 Manuel D'utilisation

Masquer les pouces Voir aussi pour GZ-MS100:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

FURTHER INFORMATION

Troubleshooting

The camcorder is a microcomputer-controlled
device. External noise and interference (from
a TV, a radio, etc.) might prevent it from
functioning properly.
The following phenomena are not
malfunctions.
The camcorder heats up when it is used
for a long time.
The battery heats up during charging.
When playing back a video file, the
image stops momentarily or the sound is
interrupted at junctions between scenes.
Trouble
No power is supplied.
The power does not
turn on, or the battery
operation time is
extremely short even
after the battery is fully
charged.
The power/charge
lamp on the camcorder
does not light during
charging.
Recording cannot be
performed.
During recording, the
date/time does not
appear.
Digital zoom does not
work.
L
Connect the AC adapter securely.
Detach the battery pack once again and reattach it firmly.
Replace the dead battery with a fully charged one.
Make sure to use the camcorder under appropriate
operating temperatures.
The battery is worn out and needs to be replaced. Please
purchase a new one.
Charging may stop in places subject to extremely high/low
temperatures to protect the battery. It is recommended
to charge it in places with a temperature of 10°C to 35°C
(50°F to 95°F).
When the battery is already fully charged, the lamp does
not light. Check the remaining battery power.
SD card is full. Delete unnecessary files or replace the SD
card.
Touch the DISP button once.
Change the settings in [ZOOM].
Digital zoom is not available in the still image recording
mode.
To solve the problem, first follow the
instructions below.
If the problem is not solved, reset the
camcorder. (Z below)
If the problem persists, please consult your
nearest JVC dealer.
To reset the camcorder
1) Close the LCD monitor to turn off the
camcorder and remove the power
supply (battery pack or AC adapter)
from the camcorder, then reattach it.
2) Select [FACTORY PRESET] from the
MENU.
Action
Z
14
14
36
15
20
13


Publicité

Chapitres

Table des Matières
loading

Table des Matières