Necessary Settings Before Use; Charging The Battery Pack; Date/Time Setting - JVC GZ-MS100 Manuel D'utilisation

Necessary Settings before Use

Charging the Battery Pack

1
Close the LCD monitor to turn off the
camcorder.
2
Attach the battery pack.
Slide the battery pack down until it locks
in place.
Bottom of the Camcorder
3
Connect the AC adapter.
DC Jack
AC Adapter
•
The charge lamp blinks to indicate charging
has started.
•
When the lamp goes out, charging is
finished. Unplug the AC adapter (or
the power cord) from the AC outlet and
disconnect the AC adapter from the
camcorder.
L
To detach the battery pack
Slide and hold BATT. (Z step 2), then
remove the battery pack.
L
To check the remaining battery power
See page 15.
1
battery pack.
BATT.
To AC Outlet
(110V to 240V)
NOTES
•
You can also use the camcorder with just
the AC adapter.
•
Please do not pull or bend the AC adapter
plug and cable. This may damage the AC
adapter.

Date/Time Setting

1
Open the LCD monitor to turn on the
camcorder.
2
When [SET DATE/TIME!] appears,
select [YES] within 10 seconds.
If you do not select within 10 seconds, the
screen disappears. In such case, press the
power button ( ) and turn the camcorder
on again.
Charge
lamp
3
Set the date and time.
Repeat this step to input the month, day,
year, hour and minute.
4
Touch the OK button to finish.
L
To change the date and time
1) Touch the MENU button.
2) Select [BASIC SETTINGS], and then
[CLOCK ADJUST].
3) Set the date and time.
L
To return to the previous screen
Select
L
To quit the screen
Touch the MENU button.
@
.