Makita DUR189 Manuel D'instruction page 9

Nylon cutting head
Optional accessory
NOTICE:
The bump feed will not operate properly if
the head is not rotating.
► 1. Most effective cutting area
The nylon cutting head is a dual string trimmer head
provided with a bump & feed mechanism.
To feed out the nylon cord, tap the cutting head against
the ground while rotating.
NOTE: If the nylon cord does not feed out while
tapping the head, rewind/replace the nylon cord
by following the procedures described under
"Maintenance".
Adjusting the shaft length
WARNING:
Before adjusting the shaft length,
release the switch trigger and remove the battery
cartridge from the tool. Failure to release the trig-
ger and removing the battery cartridge may cause a
personal injury.
CAUTION:
Make sure to tighten the lock
sleeve before operation. Otherwise the tool may
lose control and result in personal injury.
To adjust the length of the shaft, turn the lock sleeve
counterclockwise until the arrow mark on the lock
sleeve indicates the unlock mark on the housing, and
pull out or push in the shaft to the desired length.
After adjustment, tighten the lock sleeve until the arrow mark
on the lock sleeve indicates the lock mark on the housing.
1
2
► 1. Shaft 2. Lock sleeve
ASSEMBLY
WARNING:
switched off and battery cartridge is removed
before carrying out any work on the tool. Failure to
switch off and remove the battery cartridge may result
in serious personal injury from accidental start-up.
1
WARNING:
completely assembled. Operation of the tool in a
partially assembled state may result in serious per-
sonal injury from accidental start-up.
Installing the handle
Fit the handle onto the shaft and secure it with the bolt
and the knob.
1
► 1. Handle 2. Bolt 3. Knob 4. Cutting tool side
5. Battery cartridge side
Make sure that the handle is located in the straight area
of the shaft as shown in the figure.
Installing the protector
WARNING:
protector illustrated in place. Failure to do so can
cause serious personal injury.
CAUTION:
the cutter for cutting the nylon cord.
9 ENGLISH
Always be sure that the tool is
Never start the tool unless it is
4
2
Never use the tool without the
Take care not to injure yourself on
3
5